HDMI connection, Error Messages, Description, Problem

Additional information

HDMI connection

Problem	Remedy
No HDMI audio output.	• See Switching the HDMI audio setting on page 35 to make sure that AUDIO ON
	is selected.

No HDMI video output.	• Make sure that you’ve selected this player as the HDMI input in the settings for
	the component you’re using (refer to the component’s instruction manual).
	• Check that the HDMI cable is connected properly and isn’t damaged.
	• Check that components connected using the HDMI interface are switched on
	and HDMI compatible (components must be compatible with both DVI and High
	Bandwidth Digital Content Protection (HDCP)).
	• Depending on the component you have connected, using a DVI connection may
	result in unreliable signal transfers.
	• Make sure the resolution on this player matches that of the component you have
	connected using HDMI. See Video Output settings on page 29 to change the HDMI
	resolution.
	• If the screen goes blank after changing the resolution, it means the you selected
	a resolution incompatible with your monitor. See Resetting the HDMI connection
	on page 35 to reset to the factory defaults.

Color problems occur	• Depending on the connected equipment, some HDMI Color settings may cause
with your monitor after	the picture to be displayed incorrectly. In this case, use the TV’s own video input
changing the HDMI	settings to select RGB, if possible. Alternatively, revert to the previous HDMI Color
Color setting (page 30).	setting.

Message	Description
2CH ONLY	• An operation is prohibited because it is only applicable to 2 channel sources,
	while the current source is a multichannel source.

96K	• An operation is prohibited because the source is 96 kHz digital.

SND.DEMO	• The sound demo is on. See General in Troubleshooting on page 44.

NOISY	• Background noise is too high to complete MCACC setup successfully.

ERR MIC	• An error occured during MCACC setup because the microphone is not
	connected or is not connected properly.

ERR SP	• An error occured during MCACC setup because the speakers are not connected
	or are not connected properly.

MUTING	• An operation is prohibited because the sound is muted (press MUTE).

STEREO	• An operation is prohibited because the tuner is selected.

TRAYLOCK	• The tray lock is on. See General in Troubleshooting on page 44.

KEYLOCK	• The key lock is enabled. See Key lock setting on page 37.

PHONESIN	• An operation is prohibited because the headphones are connected.

English Deutsch Français Italiano Nederlands Español