Preventing Equipment from Falling Over
After installing the stand, be sure to take special care to ensure that the Pioneer television will not fall over.
•Because of the Pioneer television’s weight, if it could fall down, this can result in injury.
•For safety, be sure to take special care to ensure that the Pioneer television will not fall over.
English
Stabilizing on TV table or other location
Stabilize the equipment as shown in the diagram using screws that are available on the market.
Ìi
• A TV table with adequate strength, width and depth should
always be used to support the Pioneer television. |
| ||
Failure to do so could result in falling over. |
|
| |
• To stabilize the Pioneer |
|
| NN JODI |
television on a TV table, use | NNUPNN UPJODI |
| |
screws that have a nominal |
| ||
diameter of 6 mm (1/4 inch). |
| ||
Select the appropriate screws |
| ||
after consulting a professional | .JONN | ||
installer if necessary. | JODI | ||
#AUTION
• A table with adequate strength should always be used to support the Pioneer television. Failure to do so could result in personal injury and physical damage.
• When installing the Pioneer television, please take the necessary safety measures to prevent it from falling or overturning in case of emergencies, such as earthquakes, or of accidents.
• If you do not take these precautions, the Pioneer television could fall down and cause injury.
• The screws, hooks and other fittings that you use to secure the Pioneer television to prevent it from overturning will vary according to the composition and thickness of the surface to which it will be attached.
• Select the appropriate screws, hooks and other fittings after first inspecting the surface carefully to determine its thickness and composition and after consulting a professional installer if necessary.
Using a wall for stabilization
1 Attaching falling prevention bolts to the Pioneer television.
2 Using strong cords to stabilize it appropriately and firmly to a wall, pillar, or other sturdy element.
•Perform this work in the same way on the left and right sides.
•The length of the cords used must be long enough to allow the stand to rotate freely.
Ìi | . | |
Use falling prevention bolts, |
| |
ropes and fittings that are |
| |
available on the market. | NNUPNN | |
Recommended bolts: | ||
UPJODI | ||
Nominal diameter M8 | ||
| ||
Length 12 mm to 15 mm (1/2 to 5/8 inch) | ||
£'BMMJOHQSFWFOUJPOCPMUT
Ó$PSET
'JUUJOHT
❖Position of table screws: Without speakers
Unit: mm (inch)
|
|
| |
| |||
| |||
|
|
| |
|
|
|
|
En
