Pioneer PDP-4330HD, PDP-5030HD manual Appendix, Troubleshooting, Problem Possible Solution

Appendix

Troubleshooting

Problem	Possible Solution
• No power.	• Make sure the Plasma Display and the Media Receiver are connected correctly.
	(See page 6.)
	• Check if you pressed TV a on the remote control unit. (See page 14.)
	If the indicator on the Plasma Display lights up red, press TV a.
	• Is the power cord disconnected? (See page 13.)
	• Has the main power been turned on? (See page 14.)
• Unit cannot be operated.	• External influences such as lightning, static electricity, may cause improper
	operation. In this case, operate the unit after first turning on the power of the
	Plasma Display and the Media Receiver, or unplugging the power cord and
	replugging it in after 1 or 2 minutes.
• Remote control unit does not	• Is the Mode switch set correctly? Slide it to the TV setting position.
operate.	• Are batteries inserted with polarity (e, f) aligned? (See page 8.)
	• Are batteries worn out? (Replace with new batteries.)
	• Are you using it under strong or fluorescent lighting?
	• Is a fluorescent light illuminated near the remote control sensor?
• Picture is cut off/with sidebar	• Is the image position correct? (See pages 22 and 41.)
screen.	• Are screen mode adjustments such as picture size made correctly? (See page
	45.)
• Strange color, light color, dark or	• Adjust the picture tone. (See pages 27 to 30.)
color misalignment.	• Is the room too bright? The picture may look dark in a room that is too bright.
	• Check the input signal setting. (See page 43.)
• Power is suddenly turned off.	• Is the sleep timer set? (See page 46.)
	• Check the power control setting. (See pages 32 and 33.)
	• The unit’s internal temperature has increased.
	Remove any objects blocking vent or clean. (See page 5.)
• No picture.	• Is connection to other components correct? (See pages 34 to 39.)
	• Has setup been done correctly after connection? (See page 43.)
	• Is the correct input selected? (See page 43.)
	• Is a non-compatible signal being input? (See page 65.)
	• Is picture adjustment correct? (See pages 27 to 30.)

Warning	Problem with Plasma Display System	Possible Solution
E01	• System cable connection	• System cables are not properly connected. Check that
		all system cables are connected properly. (See page
		6.)
E04	• Abnormal internal temperature	• The internal temperature of the Plasma Display is
		abnormally high. Check the location the System is
		installed. (See page 5.)
E06	• Abnormal internal signaling or circuit	• Turn off the power once and turn it on again. (See page
	operation of the Plasma Display	14.)

Please check to see if a warning is displayed on the screen. If the problem still cannot be solved please consult the dealer where this unit was purchased.

E-64