Pioneer PDP-50MXE20-S, PDP-60MXE20 manual Power cord connection, Attaching the ferrite cores

Installation and Connections

Power cord connection

Connect the power cord after all component connections have been completed.

AC IN

Note

Regarding the audio cable, attach the supplied ferrite core. Wind the audio cable (not supplied) around the ferrite core once, and then fasten the catch.

If you do not do this, this monitor will not conform to mandatory CE or C-Tick standards.

Audio cable (not supplied)

English

Ferrite core

2

1Connect the power cord to this unit.

2Plug the power cord into a power outlet.

CAUTION

÷Use only the power cord provided.

÷For the Plasma Display, use a three-core power cord with a ground terminal.

Always be sure to connect the power cord to a three-pronged grounded outlet and make sure that the cord is properly grounded. If you use a power source converter plug, use an outlet with a ground terminal and screw down the ground line.

NO!

Do not use a power supply voltage other than that indicated (AC 100 V to 240 V, 50 Hz/60 Hz) as this may cause fire or electric shock.

Attaching the ferrite cores

Attach the accessory ferrite core to the end of the power cord as shown in the accompanying illustration. Use the provided cable tie to prevent the ferrite core from slipping on the cable.

If you do not do this, this monitor will not conform to mandatory CE or C-Tick standards.

Ferrite core

Cable tie

To power
		To AC IN
outlet
AC power cord
	As close as possible

11

En