Using the NUDGE function

The [NUDGE (+, –)] button can be used to fine-adjust the cycle and timing of the sound output from the X-PAD FX section.

Press the [+] or [–] side of the [NUDGE (+, –)] button.

—[+]: The cycle and timing of the sound output from the X-PAD FX section are advanced. When pressed and held, the cycle and timing of the sound are advanced continuously until the button is released.

—[–]: The cycle and timing of the sound output from the X-PAD FX section are delayed. When pressed and held, the cycle and timing of the sound are delayed continuously until the button is released.

Inputting the BPM manually

Tap the [TAP] button at least 2 times in rhythm with the beat (in quarter notes) of the sound being played.

The average value of the interval at which the [TAP] button was tapped by finger is set as the BPM.

!The BPM can be set manually by pressing the [NUDGE (+, –)] button while pressing the [TAP] button.

!The BPM can be set in steps of 0.1 by pressing the [AUTO] button while pressing the [TAP] button, then pressing the [NUDGE (+, –)] button while pressing the [AUTO] and [TAP] buttons.

SCENE FX section

1 2

3

4

3

5

1SCENE FX indicator

This lights when the effect is on. The color changes according to the type of [SCENE FX] button.

2SCENE FX control

This adjusts the selected SCENE FX effect.

3SCENE FX buttons

These turn the SCENE FX effects on and off.

4SUB PARAMETER 1 control

This adjusts SCENE FX sub parameter 1.

5SUB PARAMETER 2 control

This adjusts SCENE FX sub parameter 2.

Using the SCENE FX function

1 Press one of the [SCENE FX] buttons.

Select the SCENE FX effect type.

The button that was pressed flashes.

!For details on the types of effects, see Types of SCENE FX effects on page 16.

!When the selected [SCENE FX] button is pressed again, the effect turns off.

2 Turn the [SCENE FX] control.

The selected effect is applied to the sound selected in the FX SOURCE section.

—The strength of the effect increases when the control is turned clockwise. The strength of the effect is maximum when the con- trol is turned fully clockwise.

—The strength of the effect decreases when the control is turned counterclockwise. When turned fully counterclockwise, the original sound is output, with no effect applied.

3 Turn the [SUB PARAMETER 1] control.

This adjusts the strength of the selected effect’s sub parameter 1.

—The strength of the effect increases as the control is turned clockwise from the center. The strength of the effect is maximum when the control is turned fully clockwise.

12En