Preparations for using the effects

1Slide the [ON, STANDBY] switch on the rear panel of this unit to the [ON] position.

2Check that the [INPUT] and [X-PAD] buttons are lit.

!If the [INPUT] and [X-PAD] buttons are not lit, press the buttons to light them.

3Turn the [INPUT LEVEL] control.

4Turn the [OUTPUT LEVEL] control.

5Use the effects.

For instructions on using the various effects, see the sections below.

Using the SCENE FX function

When the control at the center is turned, an effect adding new sound to the track or removing sound from the track is applied. This lets you achieve a new sound for the track.

1 Press one of the [SCENE FX] buttons.

2 Turn the [SCENE FX] control.

When the control is turned clockwise, the selected SCENE FX effect changes greatly.

When the control is turned fully counterclockwise, the SCENE FX effect is not applied; only the original sound is output.

Using the ISOLATE FX function

When the [LOW], [MID] or [HI] control is turned, the strength of the low, mid or high frequency effect increases or decreases. It is also possible to isolate the sound of specific instruments in the low, mid or high frequency ranges and increase or decrease the number of sounds.

1Press one of the [ISOLATE FX] buttons.

2Turn the [LOW], [MID] or [HI] control.

When the control is turned clockwise or counterclockwise, the selected ISOLATE FX effect changes.

When the control is set to the center position, the ISOLATE FX effect is not applied; only the original sound is output.

Using the X-PAD FX function

With this function, effects can be applied to this unit’s internal sound sources and added to the currently playing track. Instead of the internal sound sources, it is also possible to load and use sampled sound sources prepared on SD memory cards and to sample and use the currently playing sound.

1Press one of the [X-PAD FX] buttons.

2Touch the [X-PAD].

The selected X-PAD FX effect changes depending on the position on the [X-PAD] that is touched.

Using the RELEASE FX function

When the [RELEASE FX] lever is moved towards you, the original sound disappears and only the effect sound is output. Move the lever is back to its original position to transition smoothly from the effect sound to the original sound.

1Switch the [RELEASE FX] selector switch.

2Move the [RELEASE FX] lever towards you.

The selected RELEASE FX effect changes according to the position of the lever.

When the lever is moved back to its original position, the effect turns off. Any SCENE FX, ISOLATE FX or X-PAD FX effects that were on before are also turned off.

En

Guide Start Quick

9