To connect to the DJ mixer’s [MASTER OUT] terminals
Power amplifier and speakers |
| To MASTER OUT terminal | |||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
To audio input terminals
DJ player | DJ Mixer | DJ player |
1 2 3 4
1Cord hook
Hook the AC adapters’ power cord here.
!The sound will be interrupted if the AC adapter’s power cord is disconnected from the unit during playback.
R L R L
5 | 6 | 7 |
Be sure to use the power cord and AC adapter included with this product.
3ON, STANDBY switch
This switches this unit’s power between on and standby.
Using the cord hook
Hook the AC adapter’s power cord onto the cord hook to fasten it in place. This prevents the power cord from being accidentally pulled, causing the plug to get disconnected from the terminal.
!The sound will be interrupted if the AC adapter’s power cord is dis- connected from the unit during playback.
1As shown on the diagram below, extend the tip of the power cord to approximately the center of the rear panel of this unit and hook the power cord onto the bottom side of the cord hook.
4USB port
Connect to a computer.
!Connect this unit and the computer directly using the included USB cable.
!A USB hub cannot be used.
5OUTPUT terminals
Connect these to the external input terminals on a mixer, etc.
2As shown on the diagram below, move the tip of the power cord back in the opposite direction past the top of the cord hook, and hook the power cord onto the top side of the cord hook.
3Turn the tip of the power cord so that it is facing towards you, then turn it back to create a ring as shown in the diagram and insert it into the [DC IN] terminal of this unit.
2DC IN terminal
Connect the included AC adapter’s DC plug here. Wait until all connections of the equipment are completed before connecting the power cord.
8En
6INPUT terminals
Connect these to the external output terminals on a mixer, etc. When only [L (MONO)] is connected, the sound input to [L (MONO)] is also input to [R].
CAUTION
When connecting audio cables, only connect either RCA pin jacks or phone jacks, not both.
Interconnect the equipment in such a way that the flow of the audio signals does not loop. If looped connections are made, the circuitry could produce oscillations that may damage the speakers, etc.
Examples of looped connections to be avoided
!Connecting a DJ mixer’s output to this unit’s input terminals then inputting this unit’s output to the same DJ mixer’s input terminals.
!Connecting the output from a DJ mixer’s [SEND] terminals to this unit’s input terminals then inputting this unit’s output to input ter- minals other than the [RETURN] terminals on the same DJ mixer.
7Kensington security slot