Pioneer Installation and Connections, Additional Information, How to Install, Connections, Troubleshooting

Installation and Connections

English

How to Install

A speaker’s playback sound is delicately influenced by conditions in the listening room. To produce optimum listening conditions, take due consideration of the conditions of your installation location before beginning actual installation.

Place the speakers at ear level.

For a natural stereo effect, the right and left speakers should be installed in symmetrical and equidistant positions from the listening position.

Speakers should ideally be located at 30 ° angles from the listening position (together forming a total 60 ° angle), and rotated inward to face the listening position.

50 °～ 60 °

CAUTION

To promote proper cooling, please assure that sufficient space is preserved between the speakers and nearby walls or other components (minimum 30 cm or more above, behind, and to right and left sides of each speaker). Leaving insufficient space between the speaker and walls or other components may lead to rising interior temperatures, leading to malfunction or damage.

Connections

When making or changing connections, always turn off the power and disconnect the power cord from its outlet.

Also, be sure to read the operating instructions for the other components to which you are connecting these speakers.

Do not plug in the power cord until all other connections have been completed.

Use only the furnished accessory power cord.

•Do not connect to both the XLR INPUT connector and the TRS

INPUT jack at the same time.

•Make sure to set the sound level at an appropriate level as the input signals to the XLR INPUT connector (or TRS INPUT jack) and RCA INPUT jack will be mixed together, affecting the sound level.

Additional Information

Troubleshooting

If you think you are experiencing a malfunction with this unit, check the following items. Also check other devices connected to the unit. If the problem persists, consult your dealer for service.

On occasion, the unit may fail to operate properly due to static electricity or other external conditions. In this event, disconnect the power cord and wait for five minutes or more, then reconnect the power cord and check for proper operation.

Symptom	Items to Check	Remedy
No power	Is power cord connected properly?	Connect power cord to outlet.

No sound from connected audio devices, or sound is very small.

Has connected audio device been set properly?	Set device’s external input and sound volume properly.
Is connection cable connected properly?	Connect cables properly.
Are connectors or plugs dirty?	Clean connectors and plugs before connecting.
Is the sound volume set properly?	Turn the [LEVEL] dial on the rear panel clockwise and
	turn up the volume.

	Is the power turned on?	Turn on the [POWER] switch on the rear panel.
	Is the auto standby function on?	Turn off the [POWER] switch on the rear panel once,
		wait a few seconds, and then turn it back on.
Illumination (POWER indicator)	Is the power turned on?	Turn on the [POWER] switch on the rear panel.
remains turned off.	Is the auto standby function on?	Turn off the [POWER] switch on the rear panel once,
		wait a few seconds, and then turn it back on.

Speakers do not resume (turn on) from Is the level of the input signal low? standby mode.

Increase the level of the input signal.

Turn off the [AUTO STANDBY] switch to turn off the auto standby function.

Sound is distorted. Is the sound level set properly?

Slowly turn the [LEVEL] dial on the rear panel counterclockwise and turn down the volume.

Is the output level of the connected audio device set	Adjust the output level of the connected audio device
properly?	properly.
Feedback (continuous howling sound) Is the sound volume set properly?	Slowly turn the [LEVEL] dial on the rear panel
	counterclockwise and turn down the volume.
	En	5