Additional information

Specifications

Amplifier section

Continuous average power output of 120 watts* per channel, min., at 8 ohms, from 20 Hz to 20,000 Hz with no more than 0.2%** total harmonic distortion (front).

Continuous Power Output

Front. . . . . . . . . . 120 W + 120 W (20 Hz-20 kHz, 8 , 0.2%) Center . . . . . . . . . . . . . . . . 120 W (20 Hz-20 kHz, 8 , 0.2%) Surround . . . . . . 120 W + 120 W (20 Hz-20 kHz, 8 , 0.2%) Surround back

. . . . . . . . . . . . . . 120 W + 120 W (20 Hz-20 kHz, 8 , 0.2%)

Continuous Power Output

Front. . . . . . . . . . . . . . . . .150 W + 150 W (1 kHz, 6 , 1.0%) Center . . . . . . . . . . . . . . . . . . . . . . .150 W (1 kHz, 6 , 1.0%) Surround . . . . . . . . . . . . .150 W + 150 W (1 kHz, 6 , 1.0%) Surround back . . . . . . . .150 W + 150 W (1 kHz, 6 , 1.0%)

Total harmonic distortion

. . . . . . . . . . . . . . . . . . . . . 0.09% (20 Hz-20 kHz, 110 W, 8 )

Audio Section

Input (Sensitivity/Impedance)

LINE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335 mV/47 kFrequency Response

LINE. . . . . . . . . . . . . . . . . . . . . .5 Hz to 100,000 Hz dB Output (Level/Impedance)

REC . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335 mV/2.2 kTone Control

BASS . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (100 Hz) TREBLE . . . . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (10 kHz) LOUDNESS. . . . . . . . . . . . . . +4/+2 dB (100Hz/10 kHz)

(at volume position –40 dB)

Signal-to-Noise Ratio (IHF, short circuited, A network) LINE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 103 dB

Signal-to-Noise Ratio [EIA, at 1W (1kHz)]

LINE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 83 dB

*Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers

**Measured by Audio Spectrum Analyzer

Composite Video / S-Video Section

Input (Sensitivity/Impedance) . . . . . . . . . . . . . . 1 Vp-p/75 Output (Level/Impedance) . . . . . . . . . . . . . . . . . 1 Vp-p/75 Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . 65 dB Frequency Response . . . . . . . . . . . . . 5 Hz to 10 MHz dB

Component Video Section

Input (Sensitivity/Impedance) . . . . . . . . . . . . . . 1 Vp-p/75 Output (Level/Impedance) . . . . . . . . . . . . . . . . . 1 Vp-p/75 Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . 65 dB Frequency Response . . . . . . . . . . . . 5 Hz to 100 MHz dB

12

FM Tuner Section

Frequency Range . . . . . . . . . . . . . . . . 87.5 MHz to 108 MHz Usable Sensitivity . . . . . .Mono: 13.2 dBf, IHF (1.3 µV/75 ) 50 dB Quieting Sensitivity . . . . . . . . . . . . . . Mono: 20.2 dBf Stereo: 38.6 dBf Signal-to-Noise Ratio . . . . . . . . . . . Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf)

Distortion . . . . . . . . . . . . . . . . . . . . . . . . Stereo: 0.5% (1 kHz) Alternate Channel Selectivity . . . . . . . . . . .60 dB (400 kHz) Stereo Separation . . . . . . . . . . . . . . . . . . . . . . .40 dB (1 kHz) Frequency Response . . . . . . . . . . . . 30 Hz to 15 kHz ± 1dB Antenna Input . . . . . . . . . . . . . . . . . . . . . . 75 unbalanced

AM Tuner Section

Frequency Range . . . . . . . . . . . . . . . . 530 kHz to 1,700 kHz Sensitivity (IHF, Loop antenna) . . . . . . . . . . . . . . . 350 µV/m Selectivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 dB Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . 50 dB Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Loop antenna

Miscellaneous

Power Requirements. . . . . . . . . . . . . . . . . . .AC 120 V, 60 Hz Power Consumption . . . . . . . . . . . . . . . . . . . . 480 W, 630 VA In standby . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.43 W AC Outlet . . . . . . . . . . . . . . . . . . . . . (switched) 100 W MAX. Dimensions . . . . . . . . . . . . 420 (W) x 173 (H) x 465 (D) mm

(16 9/16 (W) x 6 13/16 (H) x 18 5/16 (D) in.) Weight (without package). . . . . . . . . . . . . . . . 15.4 kg (34 lb)

Furnished Parts

Microphone (for Auto MCACC setup) . . . . . . . . . . . . . . 1 AA/IEC R6P dry cell batteries . . . . . . . . . . . . . . . . . . . . . . 2 Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Warranty card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 These operating instructions

Note

Specifications and the design are subject to possible modifications without notice, due to improvements.

Cleaning the unit

Use a polishing cloth or dry cloth to wipe off dust and dirt.

When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.

Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface.

75

En

Page 75
Image 75
Pioneer VSX-1015TX operating instructions Additional information Specifications, Cleaning the unit

VSX-1015TX specifications

The Pioneer VSX-1015TX is a distinguished piece of audio equipment that caters to enthusiasts seeking an all-encompassing home theater experience. Launched in the mid-2000s, this receiver combines advanced technology with usability, making it a popular choice among music and movie aficionados.

One of the defining features of the VSX-1015TX is its robust multi-channel surround sound system. It supports up to 7.1 channels, allowing users to fully immerse themselves in their favorite films, games, and music. With a power output of 110 watts per channel, it delivers rich sound quality across various formats, enhancing the auditory experience.

The VSX-1015TX is equipped with Dolby Digital and DTS decoding, providing a comprehensive sound stage that captures every detail. Its Multi-Channel Acoustic Calibration System (MCACC) optimizes audio output based on the physical characteristics of your room. This feature intelligently analyzes the acoustics and adjusts the speakers to achieve balanced sound, ensuring that listeners receive the best audio experience possible.

Furthermore, the receiver supports many audio and video formats, including MPEG, WMA, and MP3, making it versatile for different media sources. The inclusion of HDMI inputs allows for high-definition video and audio transmission, simplifying connectivity with modern devices like Blu-ray players and gaming consoles.

Another notable characteristic of the VSX-1015TX is its user-friendly interface. The on-screen display and remote control make navigating through settings and configurations straightforward. Users can easily switch between different audio sources and adjust sound parameters to suit their preferences.

Additionally, this model is designed with several speaker configurations in mind, allowing for flexible setups. Whether you are using conventional speakers or opting for surround sound systems, the VSX-1015TX caters to various configurations, making it suitable for different home theater environments.

The Pioneer VSX-1015TX also emphasizes build quality and durability, ensuring that it can withstand the rigors of regular use while maintaining performance levels. With its blend of advanced features, streamlined usability, and robust sound performance, the VSX-1015TX remains a cherished option for those looking to enhance their audio-visual experiences at home.