Pioneer VSX-1015TX Controlling the rest of your system, Selecting preset codes directly

09Controlling the rest of your system

Chapter 9:

Controlling the rest of your system

Setting the remote to control other components

Most components can be assigned to one of the MULTI CONTROL buttons using the component’s manufacturer preset code stored in the remote.

However, please note that there are cases where only certain functions may be controllable after assigning the proper preset code, or the codes for the manufacturer in the remote control will not work for the model that you are using.

If you can’t find a preset code that matches the component you want to control, you can still teach the remote individual commands from another remote control (page 53).

Note

•TV codes (for example, codes for TV, CATV, Satellite TV or DTV) can only be assigned to the TV/SAT or TV CONT button.

•If you assign the TUNER function to another component, you will have to reassign it to the Pioneer preset code to use this receiver’s built-in tuner.

•You can cancel or exit any of the steps by pressing RECEIVER. To go back a step, press RETURN.

•After one minute of inactivity, the remote automatically exits the operation.

Selecting preset codes directly

RECEIVER	INPUT	SOURCE
	SELECT

DVD/LD		TV/SAT	DVR/VCR	TV CONT
		MULTI CONTROL
CD	CD-R/TAPE		TUNER	RECEIVER
INPUT ATT		FL DIMMER		SR
	+10			DISC
				ENTER
D.ACCESS				CLASS
TOP MENU				MENU
		TUNE
DTV MENU	ST		ST
T.EDIT		ENTER		BAND
SYSTEM		TUNE
GUIDE SETUP				RETURN

TV CONTROL

1While pressing the RECEIVER button, press and hold the 1 button.

The remote LCD display shows SETUP.

2Press the MULTI CONTROL button for the component you want to control.

The LCD on the remote displays the component you want to control.

•You can’t assign the RECEIVER button.

3	Use	(cursor left/right) to select PRESET
then press ENTER.
4	Use	(cursor up/down) to select the first

letter of the brand name of your component then press ENTER.

This should be the manufacturer’s name (for example, P for Pioneer).

5 Use (cursor up/down) to select the manufacturer’s name from the list then press ENTER.

6 Use (cursor up/down) to select the proper code from the list, then try using this remote control with your component.

The code should start with the component type (for example, DVD 009). If there is more than one, start with the first one.

To try out the remote control, switch the component on or off (into standby) by pressing SOURCE . If it doesn’t seem to work, select the next code from the list (if there is one).

•If you can’t find or properly enter a preset code, you can still teach the remote individual commands from another remote control (see Programming signals from other remote controls below).

7If your component is controlled successfully, press ENTER to confirm.

The remote LCD display shows OK.

TVVOL	INPUT	TV CH	VOL
	SELECT

52

En