Additional information | 12 |
Remote control
Symptom | Cause | Remedy |
Cannot be remote controlled. | • The remote control batteries have worn out. • Replace the batteries (see Loading the batteries on | |
|
| page 7). |
|
| |
| • Too far away or improper angle of operation. • Operate within 23 feet and a 30º angle of the remote | |
|
| sensor on the front panel (see Operating range of remote |
|
| control unit on page 30). |
|
|
|
| • There is an obstacle between the receiver | • Remove the obstacle or move to another place. |
| and the remote control. |
|
|
|
|
| • Strong light such as fluorescent light is | • Avoid exposing the remote sensor on the front panel to |
| shining onto the unit's remote control sensor. | direct light. |
|
|
|
| • Something is plugged into the CONTROL IN | • Unplug the cable from the CONTROL IN jack and use |
| jack. | remote normally (see Operating other Pioneer components |
|
| on page 23). |
|
|
|
Other components can't be | • The preset code settings are wrong. | • Input the correct preset code. |
operated with the system | • The batteries wore out and the system | • Reset the proper system settings. |
remote. | settings were cleared. |
|
The SR cable is connected, but the connected components can’t be operated with the remote.
• The SR cable hasn't been connected | • Reinsert the SR cable, making sure it’s connected to the |
properly. | right jack (see Operating other Pioneer components on |
| page 23). |
|
|
• The rest of the component connections | • Make sure an analog connection has been made |
have not been made. | between the units. |
•The component you have hooked up is not a • This feature only works with Pioneer products. Pioneer product.
Note
•If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions.
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
1Switch the receiver into standby.
2While holding down the TONE button, press and
hold the STANDBY/ON button for about three seconds.
3When you see RESET? appear in the display, press ENTER.
OK? shows in the display.
4Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
Switching the speaker impedance
We recommend using speakers of 8Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6Ω impedance rating.
• With the receiver in standby, press STANDBY/ ON while holding down the SPEAKERS button. Each time you do this, you switch between the impedance settings:
•SP 6 OHM – Use this setting if your speakers are rated at 6Ω.
•SP 8 OHM – Use this setting if your speakers are rated at 8Ω or more.
71
En