Additional information | 12 |
Positional relationship between speakers and monitor
Position of front speakers and monitor
The front speakers should be as equidistant as possible to the monitor.
TV
L | R |
45° to 60°
Position of center speaker and monitor
Since mostly dialogs are output from the center speaker, keeping the center speaker as close as possible to the screen makes the overall sound more natural. For TVs using Braun tubes, however, when installing the center speaker on the floor, adjust its angle of elevation to point it towards the listening position.
Installation on floor(Diagram as seen from the side)
Monitor
•If the center speaker is not of the shielded type, install it away from the TV.
•When installing the center speaker on top of the monitor, place it facing slightly downwards towards the listening position.
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized independent service company to carry out repair work.
Note
•If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions.
Power
Symptom | Remedy |
The power does not turn on. | • Make sure that the power cord is plugged in to an active power outlet. |
| • Try disconnecting from the power outlet, then plugging back in. |
Power cannot be turned off.
(ZONE 2 ON or ZONE 3 ON
•Press the remote control’s ZONE 2 or ZONE 3
The receiver suddenly switches | • Check that there are no loose strands of speaker wire touching the rear panel or another set of |
off or the iPod iPhone | wires. If so, |
indicator blinks. | • The receiver may have a serious problem. Disconnect from the power and call a Pioneer authorized |
| independent service company. |
|
|
During loud playback the | • Turn down the volume. |
power suddenly switches off. | • Lower the 63 Hz and 125 Hz equalizer levels in the Manual MCACC setup on page 75. |
| • Switch on the digital safety feature. While holding down ENTER on the front panel, press |
| STANDBY/ON to set this receiver to the standby mode. Use TUNE / to select D.SAFETY |
| OFF, and then use PRESET / to select 1 or 2 (select D.SAFETY OFFto deactivate this |
| feature). If the power switches off even with 2 switched on, turn down the volume. With 1 or 2 on, |
| some features may be unavailable. |
|
|
The unit does not respond | • Try switching the receiver off, then back on again. |
when the buttons are pressed. | • Try disconnecting the power cord, then connect again. |
|
|
89
En