Additional information | 11 |
Problem | Remedy |
No sound from surround or | • Connect the speakers properly (refer to page 19). |
center speakers. | • Refer to Speaker setting on page 43 to check the speaker settings. |
| • Refer to Channel level on page 44 to check the speaker levels. |
|
|
• Refer to Speaker setting on page 43 to check the surround back | |
from surround back speakers. | speaker settings. |
| • Refer to Channel level on page 44 to check the speaker levels. |
| • Refer to Using surround back channel processing on page 35 to |
| make sure surround back processing and the sound mode are set for |
| surround back sound. |
|
|
No sound from subwoofer. | • Make sure the subwoofer is switched on. |
| • If the subwoofer has a volume knob, make sure it’s turned up. |
| • The Dolby Digital or DTS source you are listening to may not have |
| an LFE channel. |
| • Switch the subwoofer setting in Speaker setting on page 43 to YES |
| or PLUS. |
| • Switch the LFE Attenuator Setup on page 46 to LFEATT 0 or |
| LFEATT 10. |
|
|
The PHASE CONTROL | • If applicable, check that the lowpass filter switch on your |
feature doesn’t seem to have | subwoofer is off, or the lowpass cutoff is set to the highest frequency |
an audible effect. | setting. If there is a PHASE setting on your subwoofer, set it to 0º (or |
| depending on the subwoofer, the setting where you think it has the |
| best overall effect on the sound). |
| • Make sure the speaker distance setting is correct for all speakers |
| (see Speaker Distance on page 45). |
|
|
Noise during playback of a | • Move the cassette deck further from your receiver, until the noise |
cassette deck. | disappears. |
|
|
No sound is output or a noise | • Set the digital volume level of the player to full, or to the neutral |
is output when software with | position. |
DTS is played back. |
|
|
|
During a playback search, | • This is not a malfunction, but be sure to turn the volume down to |
noise is output from a DTS | prevent the output of loud noise from your speakers. |
compatible CD player. |
|
|
|
Can’t operate the remote | • Replace the batteries (refer to page 6). |
control. | • Operate within 7 m, 30° of the remote sensor on the front panel |
| (refer to page 7). |
| • Remove the obstacle or operate from another position. |
| • Avoid exposing the remote sensor on the front panel to direct light. |
|
|
The display is dark or off. | • Press DIMMER on the remote repeatedly to return to the default. |
|
|
English Deutsch Français Italiano Nederlands Español
59
En