Pioneer VSX-90TXV operating instructions Controlling the rest of your system

Controlling the rest of your system 11

Chapter 11:

Controlling the rest of your system

Setting the remote to control other components

Most components can be assigned to one of the input source buttons (such as DVD/LD or CD) using the component’s manufacturer preset code stored in the remote.

However, there are cases where only certain functions may be controllable after assigning the proper preset code, or the codes for the manufacturer in the remote control will not work for the model that you are using.

To try out the remote control, switch the component on or off (into standby) by pressing SOURCE . If it doesn’t seem to work, select the next code from the list (if there is one).

7If your component is controlled successfully, press ENTER to confirm.

The remote LCD display shows OK.

Resetting the remote control presets

This will erase all preset remote control preset codes and programmed buttons.

Note

•You can cancel or exit any of the steps by pressing RECEIVER. To go back a step, press RETURN.

•After one minute of inactivity, the remote automatically exits the operation.

Selecting preset codes directly

XM RADIO	SIRIUS	DVR 2		TOPMENU		MENU
DVD	TV	DVR 1	TVCTRL		TUNE
CD-R/TAPE			ZONE 2	ST	ST	T.EDIT
CD	iPod	TUNER	RECEIVER	SETUP	ENTER	RETURN
	SLEEP	SBch	ANALOG		TUNE
				GUIDE	BAND
			ATT

TV CONTROL

1While pressing the RECEIVER button, press SETUP. The remote LCD display shows SETUP.

2Use / to select PRESET then press ENTER.

3Press the input source button for the component you want to control then press ENTER.

The LCD on the remote displays the component you want to control (for example DVD or DVR).1

4Use / to select the first letter of the brand name of your component then press ENTER.

This should be the manufacturer’s name (for example, P for Pioneer).

5Use / to select the manufacturer’s name from the list then press ENTER.

6Use / to select the proper code from the list, then try using this remote with your component. The code should start with the component type (for example, DVD 020). If there is more than one, start with the first one.2

1While pressing the RECEIVER button, press SETUP. The remote LCD display shows SETUP.

2Use / to select RESET then press ENTER. RESET flashes in the LCD display.

3Press and hold ENTER for about two seconds. The LCD shows OK to confirm the remote presets have been erased.

Confirming preset codes

Use this feature to check which preset code is assigned to an input source button.

1While pressing the RECEIVER button, press SETUP. The remote LCD display shows SETUP.

2Use / to select READ ID then press ENTER.

The LCD on the remote prompts you for the input source button you want to check.

3Press the button of the component for which you want to check the preset code, then press ENTER.

The brand name and preset code appears in the display for three seconds.

Direct function

• Default setting: ON

You can use the direct function feature to control one component using the remote control while at the same time, using your receiver to playback a different component. This could let you, for example, use the remote control to set up and listen to a CD on the receiver and then use the remote control to rewind a tape in your VCR while you continue to listen to your CD player.

Note

1You can’t assign the RECEIVER, TUNER, XM RADIO, SIRIUS or iPod buttons.

2• When using a Pioneer HDD recorder, please select PIONEER DVR 487, 488, 489 or 493.

• When using a Pioneer plasma display released prior to summer 2005, please select preset codes 637 or 660.

61

En