12Additional information

Specifications

Amplifier section

Continuous average power output of 110 watts* per channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no more than 0.09 %** total harmonic distortion (front).

Continuous Power Output (20 Hz to 20 kHz, 8 , 0.09 %)

Front. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W + 110 W Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W Surround . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W + 110 W Surround back . . . . . . . . . . . . . . . . . . . . . . . . 110 W + 110 W

Continuous Power Output (1 kHz, 6 , 1.0 %)

Front. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 W + 150 W Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 W Surround . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 W + 150 W Surround back . . . . . . . . . . . . . . . . . . . . . . . . 150 W + 150 W

Total harmonic distortion. . . . . . . . . . . . . . . . . . . . . . . . 0.09 % (20 Hz to 20 kHz, 110 W, 8 )

*Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers

**Measured by Audio Spectrum Analyzer

Audio Section

Input (Sensitivity/Impedance)

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335 mV/47 kFrequency Response (LINE) . . . . . . 5 Hz to 100 000 Hz dB Output (Level/Impedance)

REC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 335 mV/2.2 kTone Control

BASS . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (100 Hz) TREBLE . . . . . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (10 kHz) LOUDNESS . . . . . . . . . . +4 dB / +2 dB (100 Hz/10 kHz)

(at volume position –40 dB)

Signal-to-Noise Ratio (IHF, short circuited, A network)

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .103 dB Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .83 dB

FM Tuner Section

Frequency Range . . . . . . . . . . . . . . . . . 87.5 MHz to 108 MHz Usable Sensitivity . . . . . . . Mono: 13.2 dBf, IHF (1.3 µV/75 ) 50 dB Quieting Sensitivity . . . . . . . . . . . . . . . Mono: 20.2 dBf Stereo: 38.6 dBf Signal-to-Noise Ratio . . . . . . . . . . . . Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf)

Distortion . . . . . . . . . . . . . . . . . . . . . . . .Stereo: 0.5 % (1 kHz) Alternate Channel Selectivity . . . . . . . . . . . . 60 dB (400 kHz) Stereo Separation . . . . . . . . . . . . . . . . . . . . . . . . 40 dB (1 kHz) Frequency Response . . . . . . . . . . . . .30 Hz to 15 kHz ± 1 dB Antenna Input . . . . . . . . . . . . . . . . . . . . . . . .75 unbalanced

AM Tuner Section

Frequency Range . . . . . . . . . . . . . . . . . . 530 kHz to 1700 kHz Sensitivity (IHF, Loop antenna) . . . . . . . . . . . . . . . . 350 µV/m Selectivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 dB Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 dB Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Loop antenna

Miscellaneous

Power Requirements . . . . . . . . . . . . . . . . . . . AC 120 V, 60 Hz Power Consumption . . . . . . . . . . . . . . . . . . . . . 490 W, 650 VA In standby . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 W AC Outlet . . . . . . . . . . . . . . . . . . . . . . (switched) 100 W MAX. Dimensions . . . . . . 420 (W) mm x 173 (H) mm x 465 (D) mm

(16 9/16 (W) in. x 6 13/16 (H) in. x 18 5/16 (D) in.) Weight (without package) . . . . . . . . . . . .15.0 kg (33 lbs 1 oz)

Furnished Parts

Setup microphone (for Auto MCACC setup) . . . . . . . . . . . . 1 AA/IEC R6P dry cell batteries . . . . . . . . . . . . . . . . . . . . . . . 2 Remote control unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Warranty card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 These operating instructions

Note

Specifications and the design are subject to possible modifications without notice, due to improvements.

Composite Video / S-Video Section

Input (Sensitivity/Impedance) . . . . . . . . . . . . . . . .1 Vp-p/75 Output (Level/Impedance) . . . . . . . . . . . . . . . . . . .1 Vp-p/75 Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . .65 dB Frequency Response . . . . . . . . . . . . . . . . . . . . 5 Hz to 10 MHz

Component Video Section

Input (Sensitivity/Impedance) . . . . . . . . . . . . . . . .1 Vp-p/75 Output (Level/Impedance) . . . . . . . . . . . . . . . . . . .1 Vp-p/75 Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . .65 dB Frequency Response . . . . . . . . . . . . . . . . . . . 5 Hz to 100 MHz

Cleaning the unit

Use a polishing cloth or dry cloth to wipe off dust and dirt.

When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.

Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface.

76

En

Page 76
Image 76
Pioneer VSX-90TXV operating instructions Additional information Specifications, Cleaning the unit

VSX-90TXV specifications

The Pioneer VSX-90TXV is a powerhouse of a receiver that caters to the most discerning audiophiles and home theater enthusiasts. With its robust build and an impressive array of features, this model stands out as a staple in the Pioneer lineup, making it a noteworthy option for anyone looking to enhance their audio experience.

One of the most significant features of the VSX-90TXV is its impressive multi-channel amplification. It offers a powerful output of 135 watts per channel at 8 ohms, ensuring that even the most demanding audio signals are handled with ease. This receiver supports a variety of configurations, including 7.1 channel surround sound, delivering an immersive audio environment that brings movies, music, and gaming to life.

The VSX-90TXV is equipped with advanced surround sound technologies. It supports Dolby TrueHD and DTS-HD Master Audio formats, providing lossless audio that retains the original quality of recordings. The inclusion of Pioneer's proprietary MCACC (Multi-Channel Acoustic Calibration System) allows users to optimize their speaker setup for any room, by analyzing and adjusting the acoustics to provide the best possible sound.

Connectivity is another strong suit of the VSX-90TXV. It features multiple HDMI inputs, allowing for a hassle-free connection to various devices. With support for 4K Ultra HD pass-through and HDR (High Dynamic Range), it ensures that users can enjoy high-quality video along with high-fidelity audio. Additionally, there are plenty of analog and digital inputs for versatility with other audio sources.

Another remarkable aspect of the VSX-90TXV is its compatibility with wireless technologies, including Bluetooth and Wi-Fi. This allows for effortless streaming from a variety of devices, making it simple to enjoy music from smartphones, tablets, and computers. Pioneer's proprietary FireConnect technology also facilitates multi-room audio, allowing music to be played throughout the home in different zones.

Design-wise, the receiver features a sleek, modern aesthetic that blends seamlessly into any home entertainment setup. The intuitive interface and remote control make navigation simple, ensuring that users can easily access all the receiver’s features.

In summary, the Pioneer VSX-90TXV combines powerful amplification, advanced surround sound technology, and versatile connectivity options, making it an ideal choice for anyone looking to elevate their home audio experience. Whether it’s for cinematic thrills or soulful music sessions, this receiver delivers on all fronts.