14Additional information
Problem | Remedy |
No sound is output or a noise | • Set the digital volume level of the player to full, or to the neutral |
is output when software with | position. |
DTS is played back. | • Make sure the player's settings are correct and/or the DTS signal out |
| is on. Refer to the instruction manual supplied with the DVD player. |
| • Set the input signal type to DIGITAL (see Choosing the input signal |
| on page 40) |
|
|
When a search is performed | • This is not a malfunction, but be sure to turn the volume down to |
by a DTS compatible CD | prevent the output of loud noise from your speakers. |
player during playback, noise |
|
is output. |
|
|
|
Everything seems to be set up | • Check that the positive/negative speaker terminals on the receiver |
correctly, but the playback | are matched with the corresponding terminals on the speakers (see |
sound is odd. | Connecting the speakers on page 22). |
|
|
There seems to be a time lag | • See Automatically setting up for surround sound (MCACC) on page 11 |
between the speakers and the | to set up your system again using MCACC (this will automatically |
output of the subwoofer. | compensate for a delay in the subwoofer output). |
|
|
After using the Auto MCACC | • |
Setup, the speaker size | motor. Switch off all appliances in the room and rerun the Auto |
setting (LARGE or SMALL) is | MCACC Setup. |
incorrect. |
|
|
|
Can’t operate the remote | • Replace the batteries (refer to page 5). |
control. | • Operate within 7 m, 30° of the remote sensor on the front panel (refer |
| to page 35). |
| • Remove the obstacle or operate from another position. |
| • Avoid exposing the remote sensor on the front panel to direct light. |
| • |
| jack and use remote normally (see Operating other Pioneer components |
| on page 25). |
|
|
The display is dark or off. | • Press FL DIMMER on the remote control repeatedly to return to the |
| default. |
|
|
| • Reinsert the SR cable, making sure it’s connected to the right jack |
cable is connected, but the | (see Operating other Pioneer components on page 25). |
connected components can’t | • Make sure an analog connection has been made between the units. |
be operated with the remote. | • This feature only works with Pioneer products. |
|
|
80
En