06Listening to your system
Choosing the input signal
You need to hook up a component to both analog and digital inputs on the rear of the
receiver to select between input signals.1
ADVANCED | ST/DIRECT | SIGNAL |
STANDARD SURR | /AUTO SURR | SELECT |
LISTENING MODE
1Press SIGNAL SELECT on the front panel to select the input signal corresponding to the source component.
Press repeatedly to select between:
•AUTO – This automatically switches to DIGITAL if a digital source is detected, otherwise it remains on ANALOG.
•ANALOG – Selects the analog inputs.
•DIGITAL – Selects the digital input.
When set to DIGITAL or AUTO, 2 DIGITAL lights when a Dolby Digital signal is input, and DTS lights when a DTS signal is input.
Note
1• This receiver can only play back Dolby Digital, PCM
•You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make the proper digital connections (page 14) and set the signal input to DIGITAL.
•Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
40
En
