Pioneer VSX-AX2AV-G, VSX-AX4AVi-G manual Using multi operations, Using System off

11Controlling the rest of your system

5 Use	to select a command in the sequence then
press ENTER.

If this is the first command in the sequence, select 1ST CODE. Otherwise, simply choose the next command in the sequence. PRES KEY flashes after you press ENTER.

6If necessary, press the input source button for the component whose command you want to input.

This is only necessary if the command is for a new component (input source).

7Select the button for the command you want to input.

The following remote control commands can be selected:

RECEIVER INPUT	SYSTEM OFF
	SOURCE
SELECT

CD		TV	VIDEO 2
DVD		SAT	VIDEO1	TVCONT
DVR2		CD-R	MULTI IN	ROOM2/3
DVR1	iPod		TUNER	RECEIVER
	SLEEP		VIDEO	ANALOG
			SEL	ATT
	SR+		DIMMER				TV CONTROL
					TV VOL		INPUT	TV CH	VOL
							SELECT
D.ACCESS	+10			CLASS
				DISC
				ENTER
AVPARAMETER				CH LEVEL		A	REC		MUTE
TOP MENU				MENU
		TUNE			MPX		EON	REC STOP
	ST		ST	T.EDIT		B	C	D	E
SETUP		ENTER		RETURN	AUDIO		SUBTITLE	HDD	DVD
		TUNE			DISP			CH	CH
PTY SEARCH			BAND
GUIDE					STATUS		SIGNAL SEL	SBch	STEREO

TV CONTROL

•You don't need to program the receiver to switch on or off. This is done automatically.

With Pioneer components, you don’t need to:

•program the power to switch off in a shutdown sequence (except DVD recorders);

•program the power to switch on if it’s the source component selected in step 3;

•program a Pioneer TV or monitor to switch on if the input function (selected in step 2) has video input terminals;

These take priority in multi operations (not shutdown).

8Repeat steps 5–7 to program a sequence of up to five commands.

9 When you’re finished, use	to select EDITEXIT
from the menu and press ENTER.

You will return to the remote control SETUP menu. Select

*EXIT * again to exit.

Using multi operations

You can start multi operations with the receiver switched on, or in standby.

STATUS	SIGNAL SEL	SBch	STEREO
MULTI OPE	THX	STANDARD	ADV. SURR

SHIFT PHASE MCACC S.DIRECT

RECEIVER

1 Press MULTI OPE.

MULTI OP flashes in the display.

2Press an input source button that has been set up with a multi operation.

The receiver switches on (if it was in standby) and the programmed multi operation is performed automatically.

Using System off

	INPUT		SYSTEM OFF	STATUS	SIGNAL SEL	SBch	STEREO
RECEIVER			SOURCE
	SELECT
				MULTI OPE	THX	STANDARD	ADV. SURR
				SHIFT	PHASE	MCACC	S.DIRECT
CD	TV	VIDEO 2			RECEIVER
DVD	SAT	VIDEO1	TVCONT

1 Press MULTI OPE.

MULTI OP flashes in the display.

2 Press SOURCE.

The command sequence you programmed will run, then

all Pioneer components will switch off1, followed by this receiver.

Note

1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.

70

En