|
| Additional Information |
|
|
|
|
|
|
|
|
|
Symptom | Cause | Remedy |
|
|
|
Broadcast stations cannot be selected | • Weak radio signals. | • Connect an outdoor antenna (refer |
automatically. |
| to page 8). |
No sound from surround or center speakers.
•Speaker settings are incorrect.
•The rear and/or center levels are turned down.
•The surround and/or center speakers are disconnected.
•Refer to “SPEAKER setting mode” on page 16 to check the speaker settings.
•Refer to “Adjusting the speaker volume” on page 20 to check the speaker levels.
•Connect the speakers (refer to page 13).
Sound is produced from other components, but not from LD or DVD player.
•SIGNAL SELECT is set incorrectly.
•The digital inputs are assigned incorrectly, or not at all.
•Set SIGNAL SELECT to "DIGITAL" or "ANAROG" according to the type of connections made. (refer to page 26)
•Set the digital input setting correctly (refer to page 15, 19).
Cannot be remote controlled. | • The remote control batteries have |
| worn out. |
| • Too far away or bad angle of |
| operation. |
| • There is an obstacle between the |
| receiver and the remote control. |
| • Strong light such as fluorescent |
| light is shining onto the unit's |
| remote control signal light- |
| receiving window. |
| • A cord is connected to the |
| CONTROL IN terminal on this unit. |
•Replace the batteries (refer to page 6).
•Operate within 23 feet (7 m), 30° of the remote sensor on the front panel (refer to page 7).
•Remove the obstacle or operate from another position.
•Avoid exposing the remote sensor on the front panel to direct light.
•Connect cord to the correct jack.
The display is dark. | • This is not a malfunction. |
•In standby, pressing 
STANDBY/ ON while holding down the 
button (both on the front panel) returns the display to the default brightness.
If the unit does not operate normally due to external effects such as static electricity
Disconnect the power plug from the outlet and insert again to return to normal operating conditions.
45
<ARB7192>
