Pioneer VSX-D908S Speaker impedance, Speaker terminals, While holding down the Speakers button

Connecting Your Equipment

7Speaker terminals

1 Twist exposed wire	2 Loosen speaker	3 Tighten terminal.	The speaker terminals also
strands together.	terminal and insert		accept single banana
	exposed wire.		plugs.
			(Refer to speaker manual
			for details.)

3/8 in.(10 mm)

Speaker impedance

You can change the speaker impedance to suit the kind of speakers you have in your home system but we recommend using speakers with an impedance of 8 Ω -16 Ω (the default setting). If you are using 6 Ω less than 8 Ω impedance speakers, you need to change the impedance setting.

STANDBY/ON						First turn the receiver off, then press the power button
						while holding down the SPEAKERS button.
AUDIO/VIDEO MULTI-CHANNEL RECEIVER NºmÀ				/?ùºDigital￿ Signal P		Choose the impedance setting by pressing the SPEAKERS button again.
STANDBY/ON	DSP	STEREO				You can choose the 8 Ω-16 Ω setting or the 6 Ω-8 Ω setting.
STANDBY	MODE
	/DTS
SIGNAL SELECT ADVANCED		STANDARD
						SIGNAL	VOLUME	(This display indicates an 6 Ω less than
						SELECT	dB
						ANALOG SP A
	VIDEO INPUT		DECODER IN DIRECT LOUDNESS MIDN					8 Ω impedance setting)
5-CHANNEL EQUAL POWER OUTPUT			EXTERNAL
S-VIDEO	VIDEO L	AUDIO R
PHONES
			SPEAKERS	– BASS +	–
							To check which impedance the amp is set to hold down the
	SPEAKERS						SPEAKERS button for 2-3 seconds. You’ll get a display like the
							one shown below right telling you the speaker impedance
							setting.
						SIGNAL	VOLUME	SIGNAL	VOLUME
						SELECT		SELECT
						ANALOG SP A		ANALOG SP A
							dB	or	dB
						(This display indicates a 6 Ω less		(This display indicates an 8 Ω-16 Ω
						than 8 Ω impedance setting)		impedance setting)

PREPARATION

15