Pioneer S-DV333, XV-DV434 manual Using this unit with a Pioneer plasma display, 08Other connections

08Other connections

Using this unit with a Pioneer plasma display

If you have a Pioneer plasma display (models PDP-504HDG and PDP-434HDG, you can use

an SR+ cable1 to connect it to this unit and take advantage of various convenient features, such as automatic video input switching of the plasma display when the input is changed.

Media receiver

CONTROL

OUT

Pioneer plasma display

XV-DV333/434

Using the SR+ mode with a Pioneer plasma display

When connected using an SR+ cable, a number of features (such as automatic video

input switching and volume muting3 on the plasma display) become available to make using this unit with your Pioneer plasma display even easier.

See also SR+ Setup for Pioneer plasma displays on page 23 for information on setting up the unit.

1	Make sure that the plasma display and
this unit are switched on and that they are
connected with an SR+ cable.
See Using this unit with a Pioneer plasma
display above for more on connecting these
components.
2	Press SR+ on the remote.

OPTICAL IN
AUDIO
LINE 2	CONTROL
	ANTENNA UNBALFM
COMPONENT		75Ω

VIDEO OUT

Y PB

VIDEO	PR S-VIDEO
OUT	VIDEO	OUT

AM LOOP ANTENNA

3 When you see ‘Setup?’ appear in the

display, use	to select ‘SR+ On’ or ‘SR+
Off’.

•If SR+ Error shows in the display, it means there is a communication problem between the unit and the plasma display.4 Check all connections and retry.

•Use a 3-ringed miniplug SR+ cable to connect the CONTROL IN jack of this unit through a media receiver to the CONTROL OUT jack of your plasma display.2

Before you can use the extra SR+ features, you need to make a few settings in the unit. See SR+ Setup for Pioneer plasma displays on page 23 for detailed instructions.

Note

1The 3-ringed SR+ cable from Pioneer is commercially available under the part number ADE7095. Contact the Pioneer Cus- tomer Support division for more information on obtaining an SR+ cable.

2You won’t be able to use the remote sensor of this unit with the CONTROL IN jack of this unit connected to the CONTROL OUT jack of your plasma display. You can use the remote sensor of the plasma display (even in standby) as long as the power isn’t switched off.

3The automatic volume muting feature is enabled separately; see SR+ Setup for Pioneer plasma displays on page 23.

4If you disconnect the SR+ cable or switch the plasma display off while SR+ is on, the setting automatically reverts to SR+ OFF. This displays an error if you switch the input of the unit with the plasma display switched off. Likewise, if this unit is switched off, the link with the plasma display will be terminated.

32

En