Pioneer XW-NAS5 13

iPod playback

Important

If an error message lights in the front panel, try following the points below:

Message What it means

There is a problem with the signal path from the iPod to the unit. Reconnect the iPod to the unit. If this doesn’t seem to work, try resetting your iPod.

An unsupported device has been connected. Check whether the iPod

was supported by this unit.

The iPod that is not supported is connected. Check whether the iPod was supported by this unit (page 10).

When the iPod software version is too old, update the iPod software to the latest version.

When there is no response from the iPod, update the iPod software to the latest version. If this doesn’t seem to work, try resetting your iPod.

If the iPod cannot be operated, check the following items:

•Is the iPod connected correctly? Reconnect the iPod to the unit.

•Is the iPod experiencing a hangup? Try resetting the iPod, and reconnect it to the unit.

Tip

•iPod recharging occurs whenever an iPod is connected to this unit. (This function is supported in standby mode as well.)

•Whenever an iPod is connected to this unit, turning the unit’s power ON or switching input to iPod will cause iPod playback to begin automatically.

•When input is switched from iPod to another function, the iPod playback stops automatically.

•If the unit is set to standby when an iPod is connected, the iPod’s power will be turned OFF automatically.

Español Nederlands Italiano Français Deutsch English