Bluetooth® ADAPTER for Wireless Enjoyment of Music | 04 |
1Switch the unit into standby and connect Bluetooth ADAPTER to the ADAPTER PORT located in the rear panel.
2Press STANDBY/ON.
3Press INPUT to switch the unit to ‘ 
’.1 When pairing has not been performed,
‘ 
’ is displayed.
Setting the PIN code
Set this unit’s PIN code to the same setting as that for the Bluetooth wireless technology device used. Supported PIN code setting values include 0000, 1234 or 8888.
• Default setting: 0000
PRESET |
| PRESET | |
|
| ENTER | |
|
| TUNE | |
SLEEP | WAKE | BASS/ | |
UP | TREBLE | ||
|
1Switch the unit into standby.
2Press and hold for three seconds. The new PIN code will be displayed, indicating that the PIN code has been changed.
Repeat step 2 until the PIN code is reset to the value desired.
Pairing Bluetooth ADAPTER and Bluetooth wireless technology device
“Pairing” must be done before you start playback of Bluetooth wireless technology content using Bluetooth ADAPTER. Make sure to perform pairing first time you operate the system or any time pairing data is cleared. “Pairing” is the step necessary to register Bluetooth wireless technology device to enable Bluetooth communications.2 For more details, see also the operating instructions of your Bluetooth wireless technology device.
PRESET |
| PRESET | |
|
| ENTER | |
|
| TUNE | |
SLEEP | WAKE | BASS/ | |
UP | TREBLE | ||
|
1 When ‘
’ lights, press .
‘
’ will flash, and the unit will enter the pairing standby mode.
2Switch on the Bluetooth wireless technology device that you want to make pairing, place it near the system and set it into the pairing mode.
Pairing begins.
3Check to see that the Bluetooth ADAPTER is detected by the Bluetooth wireless technology device.
lights when Bluetooth wireless technology device is connected.
lights when Bluetooth wireless technology device is not connected. In this case, perform the connection operation from the side of the Bluetooth wireless technology device.
Español Nederlands Italiano Français Deutsch English
Note
1When the Bluetooth ADAPTER is not plugged in the ADAPTER PORT, 
cannot be selected even if INPUT is pressed.
2• Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology device.
15
En