Pitney Bowes DI200 manual Loading the Insert Feeder Feeder C

Loading

Loading the Insert Feeder (Feeder C)

Insert Feeder C is only available on certain machine configurations. Use this feeder to add additional inserts to your envelope that do not require folding by the machine. Feeder C is especially suited to feeding pre-folded or thicker inserts such as business reply envelopes (BREs), response cards and similar materials.

Always fan (aerate) inserts before you load them. This prevents them from sticking together.

Then tap the stack of inserts onto a firm surface to align the edges.

Place the insert stack into Feeder C.

IMPORTANT: The orientation of the insert stack depends on the nature of the material being run. For pre-folded inserts, it’s normally best to load with the “closed” edge feeding first. You can usually load business reply envelopes right way up and facing you. However, if the flaps are pulled open when feeding, try loading the envelopes with the flaps down and facing you.

Slide the two side guides up to the
insert stack then slightly back them off.
Use the blue handles at the rear of the
guides when moving them.
IMPORTANT: The setting is correct
when the guides control the inserts but
in no way restrict their feed into the
machine or cause them to feed at an
angle (skew). If the guides are too tight,
inserts may not feed reliably; if they are
too loose, inserts may skew as they
feed into the machine.
12	OfficeRight™ DI200 Operator’s Guide