Reference
Message | Meaning and Action |
CHECK SHEET | Sheet feeder A2 out of paper, failed to feed or a jam was not |
FEEDER A2 | cleared successfully from this area. Remove the paper in |
| sheet feeder A2, reload and start run. |
|
|
CHECK SHEET | The machine has detected a material jam between sheet |
FEEDER A2 | feeder A2 and the collation area. Open the front cover |
LIFT COVER D | cover D and remove all material inside. Close front cover |
REMOVE ALL | D. Remove material from sheet feeder A2. Reload and |
| start run. |
|
|
CLEAR FEEDER | This is due to the Manual Feeder M being blocked prior to |
M | powering the machine up or starting it up. Check that there’s |
| no material in the feeder. If there is, remove it and restart. |
|
|
CLEAR | This could be due either to a previous jam not being |
STACKER AREA | cleared correctly in the stacker area or there is a jam |
| in the stacker area. Check that stacker area is clear. |
| Remove any material and resume run. |
|
|
DOUBLE FEED | The machine has detected a double feed from sheet feeder |
CHECK FDR A1 | A1. Remove the paper in sheet feeder A1, reload and start |
| run. |
|
|
DOUBLE FEED | The machine has detected a double feed from sheet feeder |
CHECK FDR A2 | A2. Remove the paper in sheet feeder A2, reload and start |
| run. |
|
|
FOLD ONLY | Fold only has been selected but no sheets, either |
REQUIRES | from feeder A1 or A2 (if applicable), have been selected. |
SHEETS | In this state the indicators for sheet feeder A1 will be red, |
| not green. Press the sheet feeder selection button until the |
| required feeder is selected. |
34 | OfficeRight™ DI200 Operator’s Guide |
