Planar LC1200R DC Power Input Requirements, DC Power Input Lines, DC Input Voltage / Current

Pulse
Vertical Front
Porch	0.381 ms 12 lines	0.318 ms 10 lines	0.770 ms 37 lines	0.053 ms 3 lines
Vertical Back
Porch	1.112 ms 35 lines	1.049 ms 33 lines	0.478 ms 23 lines	0.514 ms 29 lines
Vertical Active	12.711 ms 400	15.254 ms 480	12.480 ms 600	13.599 ms 768
Display	lines	lines	lines	lines
Vertical Sync
Polarity	-	-	-	-

Note: VGA border is not included in the active display time described above.

Note: For video mode 720 x 400 missing video rows and columns are allowed. This is a text mode only. Performance is acceptable if characters as defined section 1.2.1 are legible. Missing row or columns at the edge of the display is acceptable as long as characters remain legible.

5 DC Power Input Requirements

5.1DC Power Input Lines

The DC Power Input Connector consists of two (2) positions wired numerically and supplied attached to the LC1200R as a chassis mounted connector per definitions listed in Table 7.

Table 7. DC Power Input Connector- Pin Assignments

PIN NUMBER SIGNAL NAME

1Positive Input Voltage (12V)

2 Return (GND)

The DC Power Input Connector is a 2 pin Molex Mini Fit Jr. Pin number assignments are defined in Table 7; shown below is the physical layout as seen by the interface cable from the DC power source.

Figure 5

5.2DC Input Voltage / Current

DC Input Voltage: 12 V DC nominal, +/- .4 V DC.

Over the specified input voltage range:

•No loss of image synchronization occurs.

•White display luminance level is within 10% of luminance at nominal input voltage.

•DC Input Current: 4.3 amp maximum current draw (12.4-vdc applied) steady state conditions.

LC1200R User’s Guide 021-0183-00 Rev A 16 of 29