FGSW-2620VM / FGSW-2624SF User’s Manual

It recommends using PLANET SFPs on the Managed Switch. If you insert a SFP transceiver that is not supported, the Managed Switch will not recognize it.

Before connect the other switches, workstation or Media Converter.

1.Make sure both side of the SFP transceiver are with the same media type, for example: 1000Base-SX to 1000Base-SX, 1000Bas-LX to 1000Base-LX.

2.Check the fiber-optic cable type match the SFP transceiver model.

¾To connect to 1000Base-SXSFP transceiver, use the multi-modefiber cable- with one side must be male duplex LC connector type.

¾To connect to 1000Base-LXSFP transceiver, use the single-modefiber cable-with one side must be male duplex LC connector type.

Connect the fiber cable

1.Attach the duplex LC connector on the network cable into the SFP transceiver.

2.Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a Media Converter..

3.Check the LNK/ACT LED of the SFP slot on the front of the Switch. Ensure that the SFP transceiver is operating correctly.

4.Check the Link mode of the SFP port if the link failed. Co works with some fiber-NICs or Media Converters, set the Link mode to “1000 Force” is needed.

Remove the transceiver module

1.Make sure there is no network activity by consult or check with the network administrator. Or through the management interface of the switch/converter (if available) to disable the port in advance.

2.Remove the Fiber Optic Cable gently.

3.Turn the handle of the MGB module to horizontal.

4.Pull out the module gently through the handle.

17