3. Installing and Using VDSL Converter

3.1 Install the Ethernet Over VDSL2 Converter

The Converter does not require any software configuration. Users can immediately use any feature of this product simply by attached the cables and plug power on. There is some key limitation on the Ethernet over VDSL2 converter. Please check the following items:

●The device is used for Point-to-Point connection only

(Master device to Slave device) and allows data and voice work on the same telephone or ISDN lines.

●VC-201 Two RJ-11 connectors for VDSL port. One for voice device connection (like telephone) and the other one for network link connection.

Depending on the quality of telephone line, the maximum distance of one VDSL segment is 1.5km (5000ft) with AWG 24 telephone wires.

●VC-202 1 BNC connector and supports 50 ohm cable.

Depending on the quality of coaxial cable, the maximum distance of one VDSL segment is 1.6km with 5C coaxial cable.

●The distance will change by the quality of telephone wires and coaxial cables.

3.1.1 VC-201 LAN to LAN connection

Two sets of the converters could be used to link two local Area networks that are located in different place. Through the normal telephone line, it could setup a to 100/55Mbps

19