5.LNK LED will from blinking to illuminate.

6.Connect Ethernet port to Ethernet device via regular Cat. 5 cable.

Figure 3-4: Connecting Standalone IP device

3.3.2 Connecting Multiple PCs to an Ethernet LAN

Refer to the following procedures to setup the VC-202 to an Ethernet LAN.

1.Set the VC-202 to be CO mode or CPE mode from the DIP switch at the rear panel.

2.Power on the VC-202 by connecting its power source.

3.Power LED will illuminate.

4.Connect VDSL line / coaxial cable from another VDSL de- vice to VDSL BNC port of the VC-202.

5.LNK LED will illuminate.

6.Connect Ethernet port to Ethernet Switch (or Broadband

Router) via regular Cat. 5 cable.

24