means upstream and downstream rate are the same or similar) – the VDSL port can be RJ-11 connectors or BNC connector. The VC-201/VC-202 can be set to CO mode or CPE mode via a DIP switch. When the VC-20X-CO is used to connect to the other VC-20X-CPE as a standalone pair, up to 100/55Mbps asymmetric data rate within 200m and up to 30/6Mbps asymmetric data rate at 1km. This capability is ideal for use as an Ethernet extender for your existing Ethernet network.

PLANET’s VDSL2 Converter solution provides a much cheaper replacement and smooth migration for existing Long Reach Ethernet (LRE) networks.

The cable specifications of the connection are listed as following:

●10BASE-T, Category 3, 4 or 5 UTP

●100BASE-TX, Category 5 UTP

●Ethernet over VDSL, Twisted-pair telephone wires

●Ethernet over VDSL, Coaxial cable

The two drawings listed below are typical application for the Ethernet over VDSL converter.

 

Slave device (CPE) must connect to Master

 

device (CO) through the telephone wire. Slave

 

cannot connect to Slave and Master cannot

Note

connect to Master. To define the VC-201 to CO

or CPE, please refer to section 2.2.1 for more

 

 

detail.