●Air flow around the unit and through the vents in the side of the case is not restricted (company recommend that you provide a minimum of 25mm inch clearance)

To prolong the operational life of your units:

● Do not place objects on top of any unit or stack

3.2 Connecting VC-201

3.2.1 Connecting Standalone PC

Refer to the following procedures to setup the VC-201 to a standalone PC.

1.Set the VC-201 to be CO mode or CPE mode from the DIP switch at the rear panel.

2.Power on the VC-201 by connecting its power source.

3.Power LED will illuminate.

4.Connect VDSL line from another VDSL device to VDSL port of the VC-201.

5.LNK LED will from blinking to illuminate.

6.Connect telephone to the PHONE port.

7.Connect Ethernet port to PC Network Interface Card (NIC) via regular Cat. 5 cable.

21