VLAN Port Configuration

When the VLAN-enabled switch receives an untagged packet, the packet will be sent to the port’s default VLAN according to the PVID (port VLAN ID) of the receiving port.

To change the PVID

1.Double click the “PVID” column of a port.

2.Input a new VLAN ID (1~255).

3.Press “Enter” to submit the value.

4.Click Apply button to apply it.

NOTE:

1.All the ports are default as members of VLAN 1 and assigned PVID 1.

2.Though you can configure a VLAN group with VLAN ID from 1 to 4094, the supported PVID on this switch is only from 1 to 255.

3.The port which was assigned a PVID and the PVID is equal to VLAN ID, removing the port will not allow until you change it.

4.Automatically, a port will join the VLAN of its PVID, and if the VLAN does not exist, system will create it.

To Enable/Disable Ingress Filtering

When one packet comes in from Port X to VLAN Y, but Port X is not a member of VLAN Y:

Ingress Filter Enabled - The filter checks the packet and detects Port X does not belong to the VLAN Y, the Ingress Filter discards the packet.

Ingress Filter Disabled - All the packets destined to VLAN Y are all unobstructed. Click the “Ingress Filtering” column of a port and select ‘Enable’ to activate Ingress Filter.

Port Group VLAN

The Port Group VLAN (Port-based VLAN) is concentrate on definite ports. The packets forwarding policies are based on destination MAC addresses or related ports by voluntary learning relationship of MAC addresses and its related ports.

- All Together

- 29 -