Configuration B

Use Configuration B if:

You will NOT use the Automatic Handset Lifter and…

Your phone has built-in headset functionality (a Headset button).

Confirm there is

a “HEADSET” button on your phone

Headset Base (bottom view)

1. Plug the short BLACK Phone Cable that is pre-installed on the Headset Base into the Headset port [C] on the desk phone.

HANDSET port or HEADSET port?

You should only use the headset port if you will NOT be using the Automatic Handset Lifter AND you have a pre-programmed Headset button on your phone.

In this configuration you MUST press both the Headset button on your phone and the Call Control Button on the headset to answer/end calls.

Questions? For fast, efficient Technical Support call: 800-544-4660 Ext. 5538 5

Page 5

Image 5

Plantronics CS55 Series setup guide Configuration B, Handset port or Headset port?

Contents

CS55 Headset Base Base Power Adapter HL10 Automatic Handset Lifter CS55 Package Contents Headband Speaker Ear Loop Handset 2CONNECT Base to Desk Phone Handset port or Headset port? Configuration B Connect Headset Base to power outlet 3CONNECT Power and Charge HeadsetCharge the Headset for at least 20 Minutes before using Base Power Adapter Automatic Handset Lifter Install Automatic Handset LifterConnect Handset Lifter power cord to Headset Base Use the Extender Arm to Stabilize Handset if needed Determine Lifter position and height setting Mount the Lifter in permanent position Confi guration Dial Position Indicator To Place, Answer, or End Calls Using Your CS55 Headset SystemPowering up the Headset Set Speaking Volume Set Listening VolumeTo Mute a Call Mute control IntelliStand Switch To set the IntelliStandTM FeatureSpeaking Volume Minor Adjustment Control Talking/Muted Green Power RED Charging Amber Indicator LightsCS55 Lights and Tones Base Status Subscription System Reset Additional Information and Support Troubleshooting and Common Questions Plantronics Limited Warranty Still having problems?Maintenance Battery replacement