Polar F6 Precautions, Interference During Exercise, Transmitter Battery, Wrist Unit Battery

Models: F6

1 31
Download 31 pages 54.41 Kb
Page 27
Image 27

Transmitter Battery

The estimated average battery life span of the transmitter is 2500 hours of use. If you suspect that the transmitter battery has run out, contact your authorized Polar Service Center for a replacement transmitter. Polar recycles used transmitters.

Wrist Unit Battery

The estimated average battery life of the wrist unit is one and half year in normal use. Please note that excessive use of the backlight and the alarm signals drain the battery more rapidly. The symbol indicates low battery and that the battery should be replaced. Do not open the wrist unit yourself. To ensure the water resistance properties and the use of qualified components, the wrist unit battery should be replaced by an authorized Polar Service Center only. At the same time, a full periodic check of the Polar heart rate monitor will be done.

Note:

• If the symbol is displayed and you have switched the alarm on, the alarm will still activate one more time. After that the alarm symbol disappears. If you try to reset the alarm, the wrist unit displays Battery Low. You cannot reset the alarm until the battery is changed.

In cold conditions the low battery indicator may appear, but the indicator is deactivated when you return to a normal temperature.

Water resistance cannot be guaranteed after unauthorized service.

8. PRECAUTIONS

8.1 INTERFERENCE DURING EXERCISE

Electromagnetic Interference

Disturbances may occur near high voltage power lines, traffic lights, overhead lines of electric railways, electric bus lines or trams, televisions, car motors, bike computers, some motor driven exercise equipment, cellular phones, or when you walk through electric security gates.

Exercise Equipment

Several pieces of exercise equipment with electronic or electrical components such as LED displays, motors, and electrical brakes may cause interfering stray signals. To try to tackle these problems, relocate the wrist unit as follows:

1.Remove the transmitter from your chest and use the exercise equipment as you would normally.

2.Move the wrist unit around until you find an area in which it displays no stray reading or does not flash the heart symbol. Interference is often worst right in front of the display panel of the equipment, while the left or right side of the display is relatively free of disturbance.

3.Put the transmitter back on your chest and keep the wrist unit in this interference-free area as far as it is possible.

4.If the Polar heart rate monitor still does not work with the exercise equipment, this piece of equipment may be electrically too noisy for wireless heart rate measurement.

Crosstalk

When in non-coded mode the wrist unit picks up transmitter signals within 3 feet/1 meter. Simultaneous non-coded signals from more than one transmitter can cause an incorrect readout.

Using the Polar Heart Rate Monitor in a Water Environment

Your Polar heart rate monitor is water resistant to 100 feet/30 meters. To maintain the water resistance, do not press the buttons of the wrist unit under water.

Users measuring their heart rate in water may experience interference for the following reasons:

Pool water with a high chlorine content and seawater are very conductive. The electrodes of a transmitter may short-circuit, which prevents ECG signals from being detected by the transmitter.

Jumping into water or strenuous muscle movement during competitive swimming may cause water resistance that shifts the transmitter on the body to a location where it is not possible to pick up ECG signals.

The ECG signal strength depends on the individual and also varies depending on an individual's tissue composition. The percentage of people who have problems in heart rate measuring is considerably higher in water than in other use.

52

53

Page 27
Image 27
Polar F6 user manual Precautions, Interference During Exercise, Transmitter Battery, Wrist Unit Battery