CA
DB
Fig. 14
CONNECTING TO POWER SOURCE
CAUTION: Before connecting to power source ALWAYS MAKE SURE THE SWITCH IS IN THE OFF POSITION and that the power circuit is the same as that shown on the specification plate of the Router/Shaper.
1.Plug the motor cord into the short cord extending from the table switch box.
2. Turn the router motor switch ON motor operation will now be controlled by the switch in the front of the table.
3.With the table switch OFF , connect the long power cord extending from the table switch box to the power source.
STARTING AND STOPPING THE MOTO R
CAUTION: Before starting the motor, make sure work piece and all foreign objects are clear of bit and that guards are in place over bit.
TO START MOTOR Move switch lever (A) Fig. 15 up to the ON position.
A 
Fig. 15
TO STOP MOTOR Move switch lever (A) Fig. 15 to the OFF position.
SWITCH LOCK
The switch may be locked in the OFF position by removing the switch key while the switch is in the OFF position.
To lock switch, place switch in OFF position and pull switch key out of switch (see Fig. 16). Check to make sure switch is in OFF position.
CAUTION: DISCONNECT MACHINE FROM POWER SOURCE BEFORE REMOVING SWITCH KEY TO PREVENT ACCIDENTAL STARTING WHILE PULLING SWITCH KEY.
A
Fig. 16
11
