Porter-Cable CPLC7060V instruction manual Problem Cause Correction, Not Overtighten

PROBLEM	CAUSE	CORRECTION
Motor will not run.	Motor overload protection	Let motor cool off and reset switch
	switch has tripped.	by pressing the red button located
		on the end of the motor. If the
		overload still trips, check for
		malfunctioning capacitor or wrong
		voltage.
	Air tank pressure exceeds	Motor will start automatically when
	pressure switch "cut-in	air tank pressure drops below "cut-
	pressure".	in pressure" of pressure switch.
	Check valve stuck open.	Remove and clean or replace. DO
		NOT OVERTIGHTEN.
	Loose electrical connections.	Check wiring connection inside
		pressure switch and motor terminal
		box area.
	Possible malfunctioning	Contact Service Center for
	capacitor.	inspection or replacement if
		necessary.
	Paint spray on internal motor	Have checked by a Service Center.
		Do not operate the air compressor
	parts.
		in the spray area. See Flammable
		Vapor Warning.
	Possible malfunctioning motor.	Have checked by a local Service
		Center.
	Fuse blown, circuit breaker	1. Check fuse box for blown fuse
		and replace if necessary. Reset
	tripped.
		circuit breaker. Do not use a
		fuse or circuit breaker with
		higher rating than that specified
		for your particular branch circuit.
		2. Check for proper fuse; only dual
		element time delay fuses are
		acceptable. Use a time delay
		fuse.
		3. Check for low voltage conditions
		and/or proper extension cord.
		4. Remove check valve and clean
		or replace if it is stuck open or
		closed.
		5. Disconnect the other electrical
		appliances from circuit or
		operate the air compressor on
	Pressure release valve on	its own branch circuit.
		On an ON/AUTO pressure switch
	pressure switch has not
		equipped with a pressure relief
	unloaded head pressure.
		valve, bleed the line by pushing the
		pressure switch to the OFF position.
		If valve does not open, bend the
		lever until it does. If valve still fails
		to bleed, replace the valve
		assembly.

21-ENG