ASSEMBLY AND ADJUSTMENTS

Estimated Assembly Time: 25 - 40 Minutes.

INSTALLING THE STAND (FIG. A)

1.Unpack all parts and group by type and size. Refer to the parts list for correct quantities.

2.Bag “H” - Attach one short upper support (1) to top of leg (2) using one bolt (3) and nut (4).

NOTE:

Align detents in stand leg with support brackets to ensure proper fit.

Do not tighten bolts until stand is properly aligned (see step #8 before tightening).

3.Attach other end of short upper support (1) to top of another leg (2) using one bolt (3) and nut (4).

4.Bag “H” - Attach one short bottom support (5) to center of each leg using bolt (3) and nut (4). This completes the front frame section.

5.Assemble rear frame section in exactly the same manner.

6.Bag “H” - Join front and rear frame assemblies using two long upper supports (6) and two long bottom supports (7), bolts and nuts.

7.Bag “H” - Insert foot pad (8) into bottom of leg. Repeat for each leg.

8.Place stand on level surface and adjust so all legs are contacting the floor and are at similar angles to the floor, and detents in stand leg align with support brackets, then tighten all bolts.

NOTE: To avoid rocking, all bolts must be tightened securely.

9

 

Fig. A

10

 

 

3

4

11

 

 

 

12

 

 

6

 

 

1

8

7

5

 

 

2 Front Side

Frame Assembly

!WARNING

The stand is designed only for use with scroll saw.

Do not climb, sit or stand on the stand assembly.

Do not use the stand on uneven or unstable surface.

To avoid injury, do not connect this scroll saw to the power source until it is completely assembled and adjusted and you have read and understood this instruction manual.

MOUNTING THE SCROLL SAW (FIG. A, B)

1.To mount your scroll saw to the stand, position the leg stand on a firm, level surface.

2.Matching the holes (13) in the scroll saw base with the holes in the leg stand, place the scroll saw on the stand.

3.Secure the stand and saw using the hex head bolts (9), flat washers (10), sleeve (11-Fig. A) and nuts (12) provided.

4.Tighten all four nuts.

NOTE: Do not over tighten nuts holding saw to stand. This may damage the saw base.

Fig. B

9

 

F

F

O

 

10

13

12

12

Page 12
Image 12
Porter-Cable PCB370SS Assembly and Adjustments, Installing the Stand FIG. a, Mounting the Scroll SAW FIG. A, B