Onkyo Comprehensive Speaker Setup Guide for TX-NR5010

Speaker Setup

1 2 3 4 “Setup” 5

Main Menu Speaker Setup

Some of the settings in this section are set automatically by Audyssey MultEQ® XT32 Room Correction and Speaker Setup function (➔ page 42). For Speakers B, you need to change the settings manually.

Here you can check the settings made by

Audyssey MultEQ XT32 Room Correction and Speaker Setup function, or set them manually, which is useful if you change one of the connected speakers after using Audyssey MultEQ XT32 Room Correction and Speaker Setup function.

Press RECEIVER and use SP on the remote controller to select Speakers A or Speakers B. For details on SP, see “Selecting Speaker Layout” (➔ page 55).

Note

•These settings are not available in either of the following cases:

–a pair of headphones is connected.

–the “Audio TV Out” setting is set to “On” (➔ page 84).

–“HDMI Control(RIHD)” is set to “On” (➔ page 83) and you’re listening through your TV speakers.

Speaker Settings

If you change these settings, you must run Audyssey MultEQ XT32 Room Correction and Speaker Setup again (➔ page 42).

If the impedance of any speaker is 4 ohms or more but less than 6, set the minimum speaker impedance to 4 ohms.

If you bi-amp the front speakers, you must change the “Speakers Type(Front A)” or “Speakers Type(Front B)” setting. For details on speaker wire connection, see “Bi-amping the Front Speakers”

(➔ page 18). When connecting speakers without crossover network, you need to change the “Speakers Type(Front A)” or “Speakers Type(Front B)” setting beforehand. For details on connection, refer to “Using Speakers Without Crossover Network” (➔ page 18).

Note

•When bi-amping is used, the AV receiver is able to drive up to 7.2 speakers in the main room.

•Before you change these settings, turn down the volume.

■Speaker Impedance

`4ohms:

Select if the impedance of any speaker is 4 ohms or more but less than 6.

`6ohms:

Select if the impedances of all speakers are between 6 and 16 ohms.

■Speakers Type(Front A)

`Normal:

Select this if you’ve connected your front speakers A normally.

`Bi-Amp:

Select this if you’ve bi-amped your front speakers A.

`Digital Crossover:

Select this if you’re using speakers without crossover network.

En-66

Advanced Operations

■Speakers Type(Front B)

`No:

Select this if you’re not using speakers B.

`Normal:

Select this if you’ve connected your front speakers B normally.

`Bi-Amp:

Select this if you’ve bi-amped your front speakers B.

`Digital Crossover:

Select this if you’re using speakers without crossover network.

Tip

•If “Speakers Type(Front A)” or “Speakers Type(Front B)” is set to “Digital Crossover”, a confirmation screen appears. Select “Next (2-7. Digital Processing Crossover Network)” to display the screen for Digital Processing Crossover Network

(➔ page 71). Continue with the settings.

■Powered Zone 2, Powered Zone 3

`No

`Yes:

Zone 2/3 speakers can be used. (Powered Zone 2/3 enabled).

■11ch Playback

`No

`Yes

For 11.2-channel playback, set this setting to “Yes”. If you select front wide speakers setting in Speaker Configuration is set to “None”, it will be automatically switched to “80Hz (THX)”.

To be continued