Onkyo TX-NR5010 instruction manual En-99, Learning Commands, Deleting Acquired Commands

Learning Commands

The AV receiver’s remote controller can learn the commands of other remote controllers. By transmitting, for example, the Play command from your CD player’s remote controller, the supplied remote controller can learn it and then reproduce the exact same command when its 1is pressed in CD remote mode.

This is useful when some buttons don’t work as expected though you entered the appropriate remote control code (➔ page 95).

8RECEIVER

REMOTE

MODE

1	While holding down the REMOTE MODE button
	for the mode in which you want to use the
	command, press and hold down 8RECEIVER
	until the REMOTE MODE button lights (about 3
	seconds).
2	On the supplied remote controller, press the
	button to which you want to assign the new
	command.
3	Point the remote controllers at each other, within
	about 4 inches (10 cm) apart, and then press and

hold the button whose command you want to acquire until the REMOTE MODE button flashes.

If the command is learned successfully, the

REMOTE MODE button flashes twice.

VOLUME

INGT

E

TESTTON

SEL

CH

PRESET

D

C

DVD

-INPUT

TUNER

Within about

CH

MULTI

PHONO

GROUP

SURMODE

OR

NER

2-

DC

DISC

ER SELECTTU

VIDEO

4 inches (10 cm)

DIMM

INPUT

TAPE

1-

SLEEP

DVD

VIDEO

POWER

Supplied remote

controller

4 To learn more commands, repeat steps 2 and 3.

Press any REMOTE MODE button when you’ve finished. The REMOTE MODE button flashes twice.

Note

•The following buttons cannot learn new commands:

8RECEIVER, ALL OFF, MY MOVIE, MY TV, MY MUSIC, REMOTE MODE, MODE.

•The remote controller can learn approximately 70 to 90 commands, although this will be less if commands that use a lot of memory are learned.

•Remote controller buttons such as Play, Stop, and Pause are preprogrammed with commands for controlling Onkyo CD players, cassette decks, and DVD players. However, they can learn new commands, and you can restore the preprogrammed commands at any time by resetting the remote controller

(➔ page 96).

•To overwrite a previously acquired command, repeat this procedure.

•Depending on the remote controller used, some buttons may not respond as expected, or the learning process itself may not be possible.

•Only commands from infrared remote controllers can be acquired.

Controlling Other Components

•When the remote controller runs out of batteries, all commands acquired will be lost and will have to be learned all over again. Therefore, do not discard your other remote controllers.

■Deleting Acquired Commands

1.While holding down the REMOTE MODE button for the mode from which you want to delete a command, press and hold down 8TV until the REMOTE MODE button lights (about 3 seconds).

2.Press the REMOTE MODE button or the button from which you want to delete the command.

The REMOTE MODE button flashes twice. When you press the REMOTE MODE button, all commands learned in that mode will be deleted.

En-99