Onkyo TX-NR5010 instruction manual En-72, Audio Adjust, Multiplex/Mono, Dolby

■High Phase, Low Phase

`0º

`180º:

With this setting, you can adjust the phase of tweeters and woofers.

Tip

•Sounds processed by Digital Processing Crossover Network are played.

•You can switch from the current audio source to test noises by pressing MODE/D (Blue).

■High Distance, Low Distance

`0inch(0.0cm) to 12inch(30.0cm) in 1 inch (2.5 cm) steps.

With this setting, you can adjust the virtual position of tweeter and woofer units. Adjusting “High Distance” virtually shifts woofers behind tweeters. Adjusting “Low Distance” virtually shifts tweeters behind woofers.

Tweeter
Distance	Distance
Woofer
(Low Distance)	(High Distance)

Tip

•Sounds processed by Digital Processing Crossover Network are played.

•You can switch from the current audio source to test noises by pressing MODE/D (Blue).

Audio Adjust

1 2 3 4 “Setup” 5

Main Menu Audio Adjust

With the Audio Adjust functions and settings, you can adjust the sound and listening modes as you like.

Multiplex/Mono

■Multiplex

Input Channel

`Main

`Sub

`Main/Sub

This setting determines which channel of a stereo multiplex source is output. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on.

■Mono

Input Channel

`Left + Right

`Left

`Right

This setting specifies the channel to be used for playing any 2-channel digital source such as Dolby Digital, or 2- channel analog/PCM source in the Mono listening mode.

Advanced Operations

Output Speaker

`Center:

Mono audio is output by the center speaker.

`Left / Right:

Mono audio is output by the front left and right speakers.

This setting determines which speakers output mono audio when the Mono listening mode is selected.

Note

•If the “Center” setting is set to “None” (➔ page 67), this setting cannot be selected.

Dolby

■PL IIx Music (2ch Input)

These settings apply to only 2-channel stereo sources. If you’re not using any surround back speakers, these settings apply to Dolby Pro Logic II, not Dolby Pro Logic IIx.

Panorama

`On

`Off

With this setting, you can broaden the width of the front stereo image when using the Dolby Pro Logic IIx Music listening mode.

Dimension

`–3to 0 to +3

With this setting, you can move the sound field forward or backward when using the Dolby Pro Logic IIx Music listening mode. Higher settings move the sound field backward. Lower settings move it forward.

If the stereo image feels too wide, or there’s too much surround sound, move the sound field forward to improve the balance. Conversely, if the stereo image feels like it’s in mono, or there’s not enough surround sound, move it backward.

En-72