Porter-Cable PCB575BG Assembly and Adjustments, Installing Tool Rests FIG. A, B, C

ASSEMBLY AND ADJUSTMENTS

Estimated Assembly Time: 10 - 20 minutes.

!CAUTION

To avoid injury, make sure all parts are assembled and adjusted properly before plugging the grinder into a power outlet and turning it ON.

INSTALLING TOOL RESTS (FIG. A, B, C )

1.Bag “D” - Insert the lock knob (1) through

the flat washer (2) and the right side tool rest (3) to the right side tool rest mounting bracket (4) as shown.

NOTE: The grooved tool rest mounts on the left side of grinder.

Fig. A

4

2

3

1

2. Remove the knob (5), lock washer (6) and flat

washer (7) from the carriage bolt (8) on the lower

portion of the wheel guard.

Fig. C

ON
OFF	L	H

9

5

INSTALLING THE SPARK GUARDS (FIG. D)

1.Bag “F” - Attach the right spark guard (1) to the extended pad (2) of guard by using the bolts (3), spring washers (4) and flat washers (5).

2.Repeat for the left side spark guard.

NOTE: As the wheel wears down, the spark guards

must be re-adjusted to maintain a 1/16 in. (1.6 mm) distance.

Fig. D

21

Fig. B

8

5

INSTALLING THE EYE SHIELDS (FIG. E)

4

3

ON
OFF	L	H	7
		6
		5

3.Attach the tool rest assembly (9) to the grinder as shown.

4.Replace the washers and the lock knob (5).

5.Repeat the procedure for the left side tool rest. NOTE: When in use, the tool rests should be adjusted to within 1/8 in. (3.2 mm) of the grinding

wheel or other accessory being used.

1.Bag “D” - Attach the right eye shield (1) to the spark guard (2) by using the locking nut knob (3), lock washer (4) and the carriage bolt (5).

2.Repeat for left side eye shield.

NOTE: Adjust eye shields to appropriate distance from tool rests avoiding interference when operation.

Fig. E

	1	5
	4	2
3

10