16
PROBLEM PROBLEM CAUSE SUGGESTED CORRECTIVE ACTION
Motor will not run. 1. Not plugged into power outlet.
2. Switch and key not in ON position.
3. Motor cord cut or abraded.
4. Plug on cord is faulty.
5. Faulty motor.
6. Fuse on circuit breaks open.
1. Plug it into the power outlet.
2. Insert key and turn the switch ON.
3. Contact Porter-Cable Service Center
or Authorized Service Station for repair
or replacement.
4. Contact Porter-Cable Service Center
or Authorized Service Station for repair
or replacement.
5. Contact Porter-Cable Service Center
or Authorized Service Station for repair
or replacement.
6. Re-set; may be too many machines on
line.
Grinding wheel vibrates or
shakes.
1. Grinding wheel is not fixed properly.
2. Other.
1. Adjust grinding wheel properly.
See ADJUSTMENT section.
2. Contact Porter-Cable Service Center
or Authorized Service Station for repair
or replacement.
For assistance with your product, visit our website at www.portercable.com for a list of service centers, or call the
Porter-Cable Customer Care Center at (888) 609-9779.
TROUBLESHOOTING GUIDE
To avoid injury from an accidental start, turn the switch OFF and always remove the plug from the power source before
making any adjustments.
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our service website at www.portercable.
com. You can also order parts from your nearest Porter-Cable Factory Service Center or Porter-Cable Authorized
Warranty Service Center. Or, you can call our Customer Care Center at (888) 609-9779.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information about Porter-Cable, its
factory service centers or authorized warranty service centers, visit our website at www.portercable.com or call our
Customer Care Center at (888) 609-9779. All repairs made by our service centers are fully guaranteed against
defective material and workmanship. We cannot guarantee repairs made or attempted by others.
You can also write to us for information at Power Tool Specialists, 684 Huey Road, Rock Hill, SC 29730
(888) 609-9779 - Attention: Product Service. Be sure to include all of the information shown on the nameplate of your
tool (model number, type, serial number, etc.).
WARNING
!