TO ASSEMBLE ACCESSORIES PANEL (PCV2021)
The handle MUST be assembled to the frame
in order to safely assemble the acces- sories panel.
1.Remove top screws on handle assembly.
2.Loosen bottom screws on handle assembly.
Remove |
Loosen |
3.Place grooves in accessories panel assembly onto screws and slide panel assembly into place.
4.Place screws (removed earlier) into the top holes and secure accessories panel assembly to han- dles. Do not overtighten.
Screws |
Accessories |
Panel |
REMOVE SHIPPING PLUG (PCH2627, PCH3030)
THE
PUMP IS
SHIPPED FROM THE FACTO-
RY WITH OIL IN IT AND A RED SHIPPING PLUG TO PREVENT
ANY OIL FROM LEAKING OUT OF THE PUMP DURING SHIPMENT. ATTACHED TO THE SHIPPING PLUG IS A PLASTIC BAG (SEE THE FOLLOWING PHOTO) WHICH CONTAINS THE DIPSTICK/OIL PLUG THE SHIPPING PLUG MUST BE REMOVED AND THE DIPSTICK/OIL PLUG INSTALLED BE- FORE THE PRESSURE WASHER IS OPER- ATED.
1.Using a 17 mm wrench, remove shipping plug from pump by turning it counterclockwise. Discard plug.
2.Remove dipstick/oil plug from plastic bag. Before installing dipstick/oil plug into pump, check the pump oil level. See Pump paragraph in Mainte- nance section of this manual.
D22885 | 8 — ENG |