For Quick-Connect Turret Wands
(PCH2425, PCH2627, PCH3030, PCH3540HR):
Spray Nozzles
The turret holds five spray nozzles. Each nozzle is color coded and delivers a specific spray pattern for a particular cleaning purpose. The 0º, 15º , 25º , and 40º nozzles are high pressure nozzles. The chemical noz- zle is a low pressure nozzle.
RISK OF INJECTION OR INJURY TO
PERSON. DO NOT DIRECT DISCHARGE STREAM TOWARD PERSONS.
WHEN USING THE HIGH
PRESSURE NOZZLES, DO NOT ALLOW THE
0º nozzle - Red. This nozzle delivers a pinpoint stream and is extremely powerful. It covers a very small area of cleaning. This nozzle should only be used on surfaces that can withstand
this high pressure such as metal or concrete. Do not use on wood.
15º nozzle - Yellow. This noz- zle delivers a powerful 15 degree spray pattern for intense cleaning of small areas. This nozzle should only be used on areas that can withstand the high pressure from this nozzle.
25º nozzle - Green. This noz- zle delivers a 25 degree spray pattern for intense cleaning of larger areas. This nozzle should only be used on areas that can withstand the pressure from this nozzle.
40º nozzle - White. This noz- zle delivers a 40 degree spray pattern and a less powerful stream of water. It covers a wide area of cleaning. This nozzle should be used for most general cleaning jobs.
Chemical nozzle - Black. This nozzle is used to apply chemicals or cleaning solutions. It has the least powerful stream.
Changing Nozzles
DO NOT attempt to change nozzles while
pressure washer is running. Turn engine off before changing nozzles.
1.Pull quick connect coupler back on the end of the wand to release the nozzle.
Quick |
|
Connect | Quick |
Coupler | Connect |
Nozzles | Coupler |
|
2.Turn the turret to the desired nozzle.
3.Pull quick connect coupler back and place nozzle into quick connect coupler.
3.Push quick connect coupler over nozzle to secure in place.
HOW TO SIPHON CHEMICALS/CLEANING SOLVENTS
Siphoning chemicals or cleaning solvents is a low pressure operation.
NOTE: Use only soaps and chemicals designed for pressure washer use. Do not use bleach.
To siphon chemicals:
1.Press chemical hose onto barbed fitting located near high pressure hose connec- tion of pump as shown.
2. Place other end of chemical
hose with filter on it into container holding chemi- cal/cleaning solution.
3.On
On quick connect turret wand (PCH2425, PCH2627, PCH3030, PCH3540HR):
Change to the black chemi- cal nozzle.
4.After use of chemical, siphon clean water through chemical hose to rinse it
and pump clean. Chemicals which remain in pump can
damage it. Damage to pump due to chemicals will not be covered under war- ranty.
NOTE: Chemicals and soap will not siphon when using high pressure nozzles.
11 — ENG | D22885 |