LAN POS Printer Manager
This utility can be used to manage multiple Aura-6800L’s connected in same network under Windows as long as there is no conflicting IP in the network. This utility can assign to each LAN printer a different device name for easy recognition. In case of confusion, please check the MAC addresses listed in this utility against the MAC address label you can find under each printer.
Any PC connected in same network can use TCP/IP to use Aura-6800L in the way like a directly connected local printer. So, for direct I/O control by tools like “HyperTerminal” all commands applicable to the serial or parallel interface model can work on Aura-6800L in the same way, as Aura-6800 except the port must be TCP/IP with the IP address of the printer. Similarly, for Windows printer driver setup, please “Add Printer” and select for “Local printer” and select port “TCP/IP” with the printer IP address then uses the same Windows printer driver of Aura-6800L.
Posiflex Wi-Fi POS Printer Manager for Aura-6800W
Please set the host system to the AD-HOC mode and the IP in the same network segment with Aura-6800 which in the 192.168.192.XXX. The Posiflex Wi-Fi POS Printer Manager (PP68WMgr.exe) must use with Microsoft Comm control 6.0(MSCOMM32.ocx), therefore, please ensure that MSCOMM32.ocx installed before start the utility. Please set the Aura-6800 into normal mode that can be search by this utility. After start the software, it will automatically search printer by Broadcast or search by IP modes and show as a list. After Aura-6800 showed in the list, the setting can modify. For modify the printer setting through UART and UDP modes, please connect the cable to serial port. Please notice that Aura-6800 will reboot automatically right after change or update setting.
OPERATION GUIDE
MAINTENANCE GUIDE LINES
*Please turn off and disconnect power before opening the cover.
*The areas around the print head and motor become very hot during and just after printing, DO NOT touch them.
Page 10
