For switch position 5, if the switch is set to “ON”, the busy signal set to host only when input buffer is full. When it is set to “OFF”, busy signal is sent to host whenever the input buffer is full or an off line status occurs. Therefore, signals including the paper near end detect will generate busy signal to the host. Moreover, the printer will keep on beeping at Paper End (completely no paper) till paper is replaced when
For switch position 6, when it set to “OFF”, the paper will feed before cutting when software does not define this point and there will be a further paper feeding after cutting to prevent paper jam. Before setting this switch to “ON”, please make sure that your software will take care of enough paper feed for the paper jam prevention issue.
Switch position 7 defines the auto cutter. When needs to enable the paper auto cut function, it have to place to “Off”. On the other hands, the auto cutter function will disable when it place at “On”.
Switch position 8 defines the firmware update function. If the printer needs to update the firmware, please set to “ON” position. In order to operating perfectly, please set in “OFF” when the printer do not needs to update the firmware or in normal situation.
The factory default for each position listed as below:
Switch 1 Position | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | |
Default setup for | OFF | OFF | OFF | OFF | OFF | OFF | OFF | OFF | |
| |||||||||
|
|
|
|
|
|
|
| ||
Default setup for | OFF | ON | OFF | OFF | OFF | OFF | OFF | OFF | |
Aura | |||||||||
|
|
|
|
|
|
|
|
Software switch
Another method to setup
SW2 software switch works as following:
Page 17
