POSIFLEX Business Machines 6800 warranty SW2 Pos, Print Density

Switch	ON	OFF
position
1	Print Density (Normal, High Quality or Light)
2
3	Enable paper auto-cut at top hood	Disable paper auto-cut at top hood
	close and switch on the printer.	close and switch on the printer.
4	Full-cut mode.	Partial-cut mode.
5	Raster Bitmap Print by line print.	Raster Bitmap Print by buffer
		batch.
6	Even parity	None parity
7	XON/XOFF handshaking	DSR/DTR handshaking
8	CR code (0Dh) effective	CR code (0Dh) invalid

Effect of positions 1 & 2 of Print Density is defined as in table below:

SW2 Pos. 1	OFF	ON	ON
SW2 Pos. 2	OFF	OFF	ON
Print Density	Normal	High Quality	Light
		(low speed mode)

For the switch position 3, it is recommended to place at ON. In this way, the printer performs an automatic paper cut each time when the top hood is closed (e.g. after paper roll loaded) with the printer in operating condition. However, if it placing in OFF and the manual cutter can be engage whenever necessary. As well as it will automatically cut paper when switch on the printer when this switch position place at ON.

When switch position 4 set to “ON”, the paper will fully cut after paper printed. If the printed-paper do not needs to completely cut, please set this switch to “OFF” then the printed paper will be partially cut and left a tiny piece that user needs to rip the printed paper. When the printer set to full-cut mode, please notice that the paper should be take away immediately right after printed. Otherwise, the last paper will cut again with the next printed-paper cut. Please notice that when it place to ON, the paper will retract 6 mm before it start to print.

For switch position 5, it defines the printing behavior of the printer on graphic printing. When it is set to ON, the printer prints on each printing command received immediately. However, the printer may have to engage brake frequently waiting for next command resulting in trembling. When this switch is set to OFF, the printer starts printing only when more graphical data are collected thus performing a much smoother printing operation.

Page 18