Power Supply
The operating voltage range of the power adaptor should cover the local power supply for proper operation. The power cable, the power outlet and any power fusing arrangements must conform to local safety regulations.
Please never do any connection / disconnection when system is still powered on. Please always keep the external power adaptor in a free air circulation.
POWER ON/OFF
There must always be at least 10 seconds waiting before switching on again once the system is powered off successfully.
Power Status LED Indicator
There is an LED under the printed logo that serves for several purposes. The relationship between LED status and other conditions is summarized in following table:
LED Status | System Status | External Power | UPS Battery | Powering Up | |
Off | Off | Off | Not present | Not possible | |
Off | Off | Off | Present | Not allowed | |
Green | Off | On | No influence | Allowed | |
Blue | On | On | No influence | Not required | |
Blue/flash | On | Off | Activated | Not required | |
Green/rapid | On | Off | Running at | Not required | |
flash | low capacity | ||||
|
|
|
Hardware Power Switch
The power switch is at left side of the main unit. This switch turns the system on when slid downward, only when external power is present. The switch will always spring back to its original position when pressure is removed. This button turns the system off when slid downward again during power on status. However, if the system hangs due to any reason such as software resource conflict you may have to utilize the forced power off feature by pressing the switch downward, and holding for within 10 seconds. In case this forced power off fails, please disconnect the UPS battery if installed and the AC power supply for few minutes then reconnect them.
This switch can also be programmed as an ON only switch by the application program so that this switch will always turn the system on when activated, but will not power off the system when depressed again (the forced power off feature will not work in this mode). When using this feature, please
