Console Panel, Headlight Bezel, Wire Harness

REPAIR PARTS SNOW THROWER - - MODEL NO. PR827ES (96192004300)

HANDLES

7	4

	3			5	KEY	PART
	2				NO.	NO.	DESCRIPTION
	2				1	182906	CONSOLE PANEL
					1	182906	CONSOLE PANEL
					2	178668	HEADLIGHT BEZEL
					3	180927	FLOOD HEADLIGHT
	5	4	1		4	184471	SHOULDERSCREW10−24X.625
6		4			5	175262	SCREW 10−24 X 1.25
					5	175262	SCREW 10−24 X 1.25
					6	178770	WIRE HARNESS
					6	178770	WIRE HARNESS
					7	183784	BULB
		01.10.007-B

			KEY	PART
			NO.	NO.	DESCRIPTION
		3	1	412675X431	INTERLOCK SPRING
			1	412675X431	INTERLOCK SPRING
5	2		2	414572	INTERLOCK CAM
	2		3	178831	TORSION SPRING
			3	178831	TORSION SPRING
			4	169675	RETAINER
			5	17060410	SCREW 1/4−20 X .625
	1		6	421252X431	INTERLOCK STOP
	6	01.08.007-B

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty. 29

Page 29

Image 29

Poulan 96192004300 Console Panel, Headlight Bezel, Flood Headlight, SHOULDERSCREW10−24X.625, Wire Harness, Bulb, Retainer

Contents

Snow Thrower Model Number Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents HOW to SET UP Your Snow Thrower Assembly / PRE-OPERATIONParts Packed Separately in Carton Remove Snow Thrower from Carton Unfold Upper Handle Install Speed Control ROD See FigsInstall Traction Drive Control ROD See Figs Install Discharge Chute / Chute Rotator Head See Fig Install Auger Control ROD See Figs Check Tire Pressure Install Chute Deflector Remote Control See Figs Know Your Snow Thrower OperationPrimer Traction Recoil auxiliary starter handle used for starting the engine Meets A.N.S.I. Safety Requirements Stopping HOW to USE Your Snow ThrowerTo USE Choke Control See Fig To Control Snow Discharge See Fig To Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigTo Throw Snow See Fig Before Starting the Engine To Adjust Skid Plates See FigScraper BAR See Fig Check Engine OIL Level See Fig To Start Engine Snow Throwing TipsBefore Stopping If Recoil Starter has Frozen Maintenance Engine Cleaning To Adjust Snow Thrower Height Service and AdjustmentsChute Deflector Shear Bolts See Fig To Replace Belts See Fig To Remove Wheels See Fig To Adjust Cable Tension See FigCarburetor Engine Speed Other StorageFuel System Engine OIL Troubleshooting Service Notes KEY Part Description Auger HousingScraper BAR Auger Bearing Auger 27 RH Auger 27 LHSkid Plate LH Skid Plate RH Exploded 178675X431 Corner Bracket Clean OUT Tool Gearbox AssemblyBearing Impeller Pulley Chute Weldment Deflector Control AssemblyDeflector Weldment Deflector Seal Cable Assembly Adjustable LEVER/CABLE Rotator AssemblyCable Assembly Heat Shield Rotator Head Lower Handle Repair Parts Snow Thrower - Model NO. PR827ES HandlesPivot Support Weldment Loop Handle LH Console Panel Wire HarnessHeadlight Bezel Flood Headlight Knob RED SpacerHandle Knob Washer 3/8 Traction ROD Assembly Impeller ROD AssemblyShifter ROD TOP Shifter ROD Bottom Repair Parts Snow Thrower - Model NO. PR827ES Drive Drive Plate Assembly AssemblySpeed Selector Rubber Ring Roll PIN 3/16 Axle ShaftSprocket Clik PIN Frame Engine Model 12A114436146X421 Engine Mount Plate Traction Belt Impeller BeltIdler ARM Bracket Idler Pulley Wheel Assembly LH Repair Parts Snow Thrower - Model NO. PR827ES Wheels432335X428 432336X428 193071 Repair Parts Snow Thrower - Model NO. PR827ES BAG of PartsSafety Ignition KEY KIT Harness Conn B&S Shifter ROD TOP Shifter ROD Bottom435840 181037 Repair Parts Snow Thrower - Model NO. PR827ES DecalsDECAL, Danger DECAL, DANGER, Deflector Service Notes Service Notes Service Notes Limited Warranty

Poulan 96192004300 Console Panel, Headlight Bezel, Flood Headlight, SHOULDERSCREW10−24X.625, Bulb

Models: 96192004300 436134

REPAIR PARTS SNOW THROWER - - MODEL NO. PR827ES (96192004300)

KEY

CONSOLE PANEL

HEADLIGHT BEZEL

FLOOD HEADLIGHT

SHOULDERSCREW10−24X.625

WIRE HARNESS

BULB

KEY

INTERLOCK SPRING

INTERLOCK CAM

TORSION SPRING

RETAINER

INTERLOCK STOP