Poulan 96192002000, 420923, PP10527ES owner manual Operation, Meets A.N.S.I. Safety Requirements

OPERATION

SPARK			ENGINE OIL CAP	AUGER
PLUG			WITH DIPSTICK	CONTROL
SAFETY				LEVER
IGNITION
KEY			GASOLINE
			FILLER
			CAP
CHOKE				CHUTE
			DEFLECTOR
CON-
TROL
			FUEL
			SHUT-OFF
			VALVE
THROTTLE
/ ENGINE
CONTROL			DISCHARGE
			CHUTE
RECOIL	POWER
	CORD
(AUXILIARY)	PLUG	ELECTRIC	OIL DRAIN PLUG
STARTER
		START
HANDLE
		BUTTON	CLEAN-OUT TOOL

PRIMER

NOTE: ITEMS ABOVE

ARE SHOWN IN

THEIR TYPICAL

LOCATION ON THE

ENGINE. ACTUAL

LOCATION MAY

VARY WITH THE

ENGINE ON YOUR

UNIT.

AUGERS

FIG. 10

DISCHARGE CHUTE CONTROL LEVER

DRIVE SPEED	DEFLECTOR REMOTE
CONTROL LEVER	CONTROL LEVER

TRACTION

DRIVE

CONTROL

LEVER

LH TURN

TRIGGER

LIGHT

HANDLE

KNOB

MUFFLER

TOOLBOX

SKID PLATE

MEETS A.N.S.I. SAFETY REQUIREMENTS

Our snow throwers conform to the standards of the American National Standards Institute.

Toolbox - used to store spare shear bolts, locknuts and wrench.

Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.

Electric start button – used for starting the engine.

Recoil (auxiliary) starter handle – used for starting the engine.

Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.

Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.

Choke control - used for starting a cold engine.

LH and RH turn triggers - used to steer the snow thrower.

Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.

Traction drive control lever - used to engage power-pro- pelled forward or reverse motion of snow thrower.

Auger control lever - used to engage auger motion (throw snow).

Discharge chute control lever - used to change the di- rection the snow is thrown.

Skid plate - used to adjust height of scraper bar from the ground

Deflector remote control lever - used to change the

9 distance the snow is thrown.